Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Router: Linksys WRT-54G-TM DD-WRT Version: DD-WRT v24-sp2 (08/12/10) mega

When I go to NAT/ QoS => Port Forwarding, the list is empty. I previously had port forwards set there, and they are still actually working, so I'm guessing that it's just a display bug.

I suspect the display issue might be because of low nvram. I cleared the ttraf data, but it's still very low (size: 32095 bytes (673 left)). I've also tried lowering the maximum ports, TCP timeout, and UDP timeout values and rebooted the router, but the nvram is still low.

I haven't tried a hard reset yet because I've set a lot of configurations over the years and I don't remember all of them. If I could resolve the display issue without doing a hard reset, I can take a screenshot of each page, and then perform a hard reset and re-configure.

Any ideas on how I could resolve this would be great.

share|improve this question
    
Post this in the DD-WRT forum (dd-wrt.com/phpBB2), you're not going to get help here. Also make sure you read the wiki for your device and the announcements on the forum. –  dtech Jan 7 '13 at 23:28
    
@dtech Why are you so certain the OP won't get help here? This is a valid question, and although we might not have a huge audience for DD-WRT questions, this certainly doesn't need to be closed. –  slhck Jan 8 '13 at 9:05
    
Because this is not a configuration problem but a bug in DD-WRT or issue with DD-WRT. It's unlikely that people with sufficient knowledge are here to solve it. It would be another matter if it was a general configuration problem e.g. "how do I connect two DD-WRT routers wirelessly" –  dtech Jan 8 '13 at 12:40

1 Answer 1

I have the same problem (WRT54GL, DD-WRT v24-sp1 (07/27/08) std) and also needed to free some nvram memory. When the memory is not full, I can force ddwrt to display the forwarded ports using the add button in the gui, multiple times.

As for the problem "can't remember all settings". I downloaded all ddwrt settings by logging in with putty, turning on the log file and issuing nvram show. Then I have the settings in my local file, I can sort it and review. Through nvram command it's also possible to change the router settings.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.