Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a Dell Inspiron 1720 laptop, about 18 months old.

The problem is that the power cable keeps on falling out. It's just sitting on a desk, but minor movement can cause it to come out.

From a browse on the internet, it seems to be a reasonably common problem with Dell laptops, but there didn't seem to be any decent solutions.

Any ideas for how to fix it properly, or a "workaround"?

share|improve this question

5 Answers 5

Gorilla Glue

share|improve this answer

Duct tape fixes everything.

Properly, though? If you're adventurous and handy with a soldering iron, try replacing the internal power jack. You should be able to find a service manual for your model (via google) that describes the proper way to open the case.

Barring that, you'd have to talk to Dell about getting it fixed.

share|improve this answer

I guess that either the laptop power port or the end of the cable have worn and widened. Same happened with the S-video port on my Dell 1525. Depending on whether it's the cable or the port (and on mine I'm quite sure that it is the port), you'll probably need to get creative. If the cable- gently squeezing with pliers (careful, own risk, etc.) to make it a bit elliptical so it grips at two points. If the port (or the cable) try to widen the connection (duct tape? too thick probably, maybe something from the medicine kit).

If the laptop is stationary, then you can of course tape or glue the cable to the machine.

A new one shouldn't be too expensive..?

share|improve this answer
up vote 1 down vote accepted

The cable one day happened to end up such that it came out of the laptop, then went at a right angle and from there off the table.

It used to go straight out of the laptop and off the table, and regularly fall out.

With the new arrangement, it has never fallen out! So this accidental low-tech arrangement seems to work very well.

share|improve this answer

Cut 1mm from the width of brown tape, wrap it round the nearest end of the connector, cut off any excess. Should add that extra bit more to make it a tighter fit.

share|improve this answer

protected by studiohack Jan 3 '12 at 4:32

Thank you for your interest in this question. Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.