Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Back in the days of PATA hard drives, a person used jumpers on the drive to indicate whether the drive was the master or the slave of the channel, or to let the cable select which drive was which.

SATA drives are one-per-channel, one-per-cable, etc.

What are the jumpers for on SATA hard drives?

share|improve this question
add comment

5 Answers 5

up vote 13 down vote accepted

Some SATA drivers have jumpers for extra features, or for troubleshooting.

Example from the manual of a Western Digital SATA disk:

Set the Jumpers

The default setting for WD SATA hard drives varies depending on the model. To determine the default setting for your drive, look at the drive label on the top of the drive.

DO NOT change the default setting if you intend to use the drive in a desktop computer.

Change the jumper settings ONLY if you intend to use the drive in an enterprise storage environment. For more information on these advanced settings, obtain the full version WD SATA Installation Guide at support.wdc.com.

SSC_DIS Mode (Default) — Enable or disable the spread spectrum clocking feature. Default setting is disabled.

OPT1 — Only for factory use.

OPT2 — Only for factory use.

share|improve this answer
add comment

On a Seagate ST3500320AS, there are four pins in the jumper block. You put a jumper between two of them to limit the drive to 1.5Gb/s instead of 3Gb/s, as explained in the manual. But what are the other two?

As shown on this page, the other two pins (plus the nearest of the pair of pins used to limit the drive speed, which is a ground) make a serial port, which talks directly to the drive firmware!

share|improve this answer
add comment

See for example this.

share|improve this answer
add comment

Some SATA drives have jumpers to enable/disable 3Gb/s functionality or other backwards compatibility items.

share|improve this answer
add comment

On SATA-II drives, a jumper is sometimes used to set the drive into SATA-I mode for compatibility with older controllers.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.