0

Recently I wanted to setup IPv6 for my home network. I signed up for tunnelbroker.net service and was provided with IPs. Then I configured the IP address in my DIR-615. But It's not working..

Screenshot of IPv6 config (router):
enter image description here

Screenshot of my Win 8 network Config:
enter image description here

I also tested here but failed...

Please help..

0

1 Answer 1

0

If your hardware is D-Link DIR-615 rev. C1 or D-Link DIR-615 rev. C2. You can install Openwrt and configure IPv6.

Be careful, it can brick your router.

Details are here: http://wiki.openwrt.org/toh/d-link/dir-615?s[]=dir&s[]=615

Openwrt firmware: http://downloads.openwrt.org/attitude_adjustment/12.09/ar71xx/generic/ (file looks like "openwrt-ar71xx-generic-dir-615-c1-squashfs-factory.bin",C1 and C2 use same firmware)

Configure IPv6: http://wiki.openwrt.org/doc/howto/ipv6

On my router it's is D-Link DIR-615 rev. C2.

1
  • Mine is E4 . Is it supported?
    – Srijit B
    May 19, 2013 at 7:20

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .