I am using airodump-ng to capture authentication handshake, so I ran airodump for almost 49 minutes and the output appearing as
CH 9 ][ Elapsed: 49 mins ][ 2013-04-14 10:58 ][ fixed channel prism0: -1 BSSID PWR RXQ Beacons #Data, #/s CH MB ENC CIPHER AUTH ESSID 04:18:0F:9B:38:99 2 100 28948 457 0 6 54 . WPA2 CCMP PSK AndroidAP BSSID STATION PWR Rate Lost Packets Probes
But as mentioned on the wiki page of aircrack I should be receiving
wpa handshake message.
So please help me where I am doing wrong
set of commands:
# echo 1 | tee /proc/brcm_monitor0 //Switching my wifi in monitor mode # airmon-ng start prism0 //using airmon-ng to make sure wifi in monitor mode # airodump-ng prism0 //gives details about neighborhood wifi CH -1 ][ Elapsed: 24 s ][ 2013-04-14 09:48 BSSID PWR Beacons #Data, #/s CH MB ENC CIPHER AUTH ESSID 04:18:0F:9B:38:99 2 242 0 0 6 54 . WPA2 CCMP PSK Andro BSSID STATION PWR Rate Lost Packets Probes
Then I used
# airodump-ng -c 9 --bssid 04:18:0F:9B:38:99 -w psk prism0
which gives the output previously mentioned.
So please let me know where I am wrong because after searching on net I found it won't take much time to gather authentication handshake but I did't get anything after 49 minutes.
my wifi card is:
Broadcom Corporation Device [14e4:4365]