Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I'm trying to assign a single key (F2) to the "find" command, but I cannot find it in the list of commands.

As you can see here, I can see the "find" command when it comes to add it to the Quick Access Toolbar:

enter image description here


But when it comes to assigning keyboard shortcuts, the "find" command is nowhere to be found:

enter image description here


I'm assuming that the reason it is not displaying it is because it has a built-in CTRL+F shortcut, but I want to change that.

In short: how can I assign F2 to the "find" command?

share|improve this question
1  
Office 2003 shows it as EditFind, so it's probably listed in 2007 as HomeFind. (I don't have a copy of 2007, so I'm not 100% sure about that.) –  Davidw May 2 '13 at 1:37
    
@Davidw - Thanks. That was it. It's listed as editFind. Go figure. If you post this as an answer, I'll accept it. –  MegaHit May 2 '13 at 1:40
    
Also see last bit of my answer here. –  Karan May 3 '13 at 13:59
add comment

1 Answer

up vote 1 down vote accepted

It's listed by the section that it is part of in the ribbon, so it would be EditFind.

enter image description here

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.