Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I just finished setting up a KVM between my computer (HP running WinXP) and my display. For some reason the screen has adjusted its settings and now there's something wrong, but I can't quite put my finger on what it is. I tried playing with the resolution settings but couldn't get to the point it was at before. Is there any place where the previous settings are saved so I can go back to them?

share|improve this question
    
What KVM and what cables are you using to connect? Some KVMs might have a lower supported resolution than what you were running at before. –  Brad Patton May 10 '13 at 18:10
    
It's an Edimax EK-2U2C, connecting with USB and VGA cable. As far as I can tell the resolution now is the highest possible 1680x1050 on a Samsung 22 inch screen. –  Johnny May 10 '13 at 20:03

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Browse other questions tagged or ask your own question.