My separated graphics card broke so I want to enable on-board graphics. Problem is I can't do anything in the Bios because my monitor has no signal. What should I do?
2 Answers
Remove the broken card.
When the case is open anyway find the "CMOS clear" jumper.
Use it to reset the bios configuration to default (see the manual of the motherboard for instructions).
This should re-enable the on-board graphics, even if it was disabled previously.
-
1You can also just remove both the power to the PC and the CMOS button battery for 10ish seconds, without having to deal with the jumper.– imthemanJan 25, 2014 at 19:35
-
1@PeterMaxwell That would do it too, but sometimes these batteries are a real pain to take out (really tight socket). And some motherboards don't use the regular CR2032 battery, but something that not easily recognized as a battery. Sometimes even soldered onto the motherboard.– TonnyJan 25, 2014 at 19:48
-
True, that's a good point. So I guess just do which ever is easiest with that particular mobo.– imthemanJan 25, 2014 at 20:01
- Borrow a second separated graphics card (a working one).
- Next enter the BIOS (now visible due to the working card). Enable on-board graphics as primary.
- Shutdown, remove the borrowed card and boot from the system.
- Boot using the configuration you set in the second step.
Very easy, but assuming you can borrow a second card.
-
They could also just remove the dedicated graphics card, use the on-board graphics card instead, only possible if the motherboard has a dedicated video port though.– RamhoundJan 25, 2014 at 18:39
-
1if the motherboard is set to onboard video: disabled, then he needs to barrow a graphics card 100%. Jan 25, 2014 at 18:43
-
1
-
@Hennes My thoughts exactly. I didn't see your comment until after I posted my answer.– TonnyJan 25, 2014 at 18:53
-
Heh. I had that happen lots of times when I try to post a somewhat long answer. :) Anyway. Upvoted since it does not need additional hardware.– HennesJan 25, 2014 at 18:55