Super User is a question and answer site for computer enthusiasts and power users. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

For reasons I don't wish to get in to at the moment I need to occasionally disable Internet Protocol Version 4 (IPv4) on my wireless card, then enable it some time later.

Currently I go into the wireless cards properties and un-check IPv4 and apply it.

Later I will go into that same property screen and re-check the IPv4 box then disable/enable the network adapter to get an IP address.

Is there any way to automate the un-checking/re-checking the IPv4 box?

Thanks ~Mike

share|improve this question

you could do this in powershell like so:

Disable-NetAdapterBinding -Name MyAdapter -DisplayName "Internet Protocol Version 4 (TCP/IPv4)"

I know your question states batch file, but save this with a .ps1 extension and it should do what you need it to.

share|improve this answer
    
Also, just to note... Enable-NetAdapterBinding will reverse this. – Fazer87 May 27 '14 at 11:51
    
What version of PowerShell is needed for this? I tried on version 4 and I got Enable-NetAdapterBinding : The term 'Enable-NetAdapterBinding' is not recognized as the name of a cmdlet, function, script file, or operable program. Check the spelling of the name, or if a path was included, verify that the path is correct and try again. – mikefletcher85 May 27 '14 at 15:41

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .