0

My digium card and pri was working fine in other system but i removed and installed that digium card in other system .I have configured it but its showing only 24 channels but i have 30 channels .My digium card shows green light then red light then green and than red light and so on.

I have been follwing this tutorial

I tried to reinstall asterisk,dahdi,and configured dahdi many times following above tutorial but it still shows me 24 channels.

the card and pri were worked perfectly in the previous system.

But what could be the reason of showing 24 channels rather than 30 and changing of card light from green to red the to green aftersome seconds??

Any help would be appreciated.

5
  • 1
    You need configure card as e1,not t1
    – arheops
    Oct 9, 2014 at 21:44
  • I would also add that you should check the manual that came with the card for instructions on how to change the configuration from T1 to E1.
    – sruffell
    Oct 9, 2014 at 22:08
  • @arheops i am configuring the card as e1,as mentioned in the tutorial i followed
    – deogratias
    Oct 10, 2014 at 12:15
  • if you have 24 channels, that mean you have configured it as t1. Check output of dahdi_cfg -vvv
    – arheops
    Oct 10, 2014 at 13:59
  • ok problem solved,changed the digium card and configured it again then it showed all 30 channels.But i dont know why it happened??
    – deogratias
    Oct 11, 2014 at 6:35

0

You must log in to answer this question.

Browse other questions tagged .