Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I have a cheap 450W PSU with an exhaust fan at the rear. This fan, however, is very loud.

Is it a good idea to replace the stock PSU fan with a quiet fan with similar airflow? The PSU fan is hard-wired to the PCB in the PSU so I was intending on snipping the stock fan wires and sealing the loose ends with electrical tape. I would then connect the new quiet fan to the PWR_FAN socket on the motherboard.

Has anyone done this before themselves? Is it a good idea in the first place? Considering if my PSU fails, it could take out a couple of other components too.

share|improve this question
    
Please specify your PSU. –  MicTech Jul 20 '09 at 8:45
    
I'm pretty sure it's a generic manufacturer. I will check next time I can. –  GaryJL Jul 20 '09 at 9:15
    
@Gary, I prefer heatshrink over electrical tape. Not as easy to find, but electrical tape tends to slide or unwind over time. Also, if you have no pets you can remove try removing the fan grill as I've found that does generate some noise. –  hyperslug Aug 14 '09 at 4:37

5 Answers 5

up vote 10 down vote accepted

I have done this. It works.

If you're nervous around capacitors, be aware that they can and will store residual mains power. Practice basic safety: Unplug the psu, ground yourself against the case. Snip the wires, strip them, and use a 'decent' wire splicing method. wrapping them with electrical tape is not a good idea. Solder + heat shrink, small wirenuts, "B-connectors", etc.

I've been hit by the caps, you feel it, but it wasn't horrible. As always, proceed at your own risk, but I've done this plenty of times.

I wouldn't recommend fiddling with the rest of the components, but just a simple wiresnip on the fan leads is pretty painless.

Caveat: Some PSU's run their fan on 12V, some on 5V. If you have a multimeter, check and make sure you pick a fan rated for those speeds. Most 5V 'can' run on 12V, but it's not recommended.

share|improve this answer
1  
It's possible, and the one's I've disassembled all had 80mm fans in them. You should have some basic electronics experience like described in this response. If you don't have any electronics experience maybe you can find someone who does to help you with this. –  Bratch Aug 14 '09 at 4:15
    
+1 I've done it more than a few times with no issue, although I avoid splicing when I can. –  hyperslug Aug 14 '09 at 4:31
    
Plenty of experience of fiddling with electronics! I was more concerned with the long term survivability of my PSU. –  GaryJL Aug 14 '09 at 8:07
2  
as long as you replace the fan with a comperable one, and don't somehow short/damage things on the main pcb, the electrical scheme is unchanged. No worries bud! On a side note, if you arn't running a decent name brand, consider an upgrade soon. PC stability and longevity depend a lot on the quality of the PSU. –  Keck Aug 14 '09 at 13:31

No, in my opinion opening the PSU is NOT something you should do.

If you do anything wrong the best case scenario is that you only destroy your computer.

The worst case is that it catches fire and you burn down your house and killing everyone in it.

Sorry to sound alarmist but messing with "out of the socket AC current stuff" is best left to professionals.

share|improve this answer
2  
Instead, get a quiter PSU. –  pcapademic Jul 20 '09 at 11:09
    
Backup + fire extinguisher? –  earlNameless Jul 28 '12 at 17:28

It's not problem replace PSU fan, but you loss warranty.

I prefer Noctua Fans

share|improve this answer
    
I've got a spare AcoustiFan sitting around somewhere which should do the job. –  GaryJL Jul 20 '09 at 8:35

Can it be done? Yes.

  • Many people (including myself) have simply cut the wires to the old fan and used some electrical tape to connect the wires to a new one. Works like a charm.
  • Its not rocket science.

Should it be done? No!

  • As some people have already said, the capacitors hold some charge even when the machine is switched off, which could discharge and deliver quite a significant electrical shock.
  • I don't know about other countries, but over here (Australia) only certified electricians are supposed to work on cables that are made to carry a 250v current (Technically we are not allowed to change light bulbs). Tinkering with the inside of a PSU is no exception to this. We can do other stuff with our computers because the cables coming out of the PSU are only 12v or something like that.
share|improve this answer
    
Why not? Please elaborate. ;) –  Nikhil Chelliah Aug 14 '09 at 15:21
    
Elaborated a bit :) –  Nippysaurus Aug 17 '09 at 23:51
    
You can't even wire a plug? :O –  Kurru Oct 10 '11 at 3:34
    
Depends who you ask. The "right" thing to do is apparently get an an electrician to do it. Like if a business if trying to set a good example to their employees they will hire an electrician to wire a plug or change the light bulbs, but a lot of people also realise how stupid that is and just do it themself. –  Nippysaurus Oct 10 '11 at 3:55
    
Oh thats really stupid. In the UK I mounted 6 240v switches in a PSU case and made an elaborate switch panel for my external harddrives. Worked very well with no fire or anything ;) Dont use it anymore since getting a file server in anycase –  Kurru Oct 12 '11 at 4:32

What you suggest can definitely be done. I have replaced the fan in a PSU before, but it had a standard fan connector inside the PSU which made it easier.

I question your desire to plug the fan into the motherboard. While this would work, why not just splice the fan into the old fan wires? This would cause the two systems to be more independent of each other, create less of a wire mess, etc. Plus, with many PSUs the fan speed is controlled by the amount of heat or the current draw. You lose this functionality if you draw power from the motherboard.

share|improve this answer
    
There is a socket on the motherboard labelled PWR_FAN... –  GaryJL Aug 14 '09 at 8:04
    
And for RPM monitoring. –  GaryJL Aug 14 '09 at 8:08

protected by nhinkle Sep 24 '11 at 18:40

Thank you for your interest in this question. Because it has attracted low-quality answers, posting an answer now requires 10 reputation on this site.

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.