1

I know that it's possible to make extension cables for pretty much anything using regular UTP Cable, it's just a matter of matching both ends of the cable and that's it; but by researching a little more into this stuff, I've also learned that some cables are rated to withstand or better transport certain signals, like how much voltage or amps can it carry, or even which frequency ranges it's been made to transport reliably from one end to another, but I'm no expert in electric stuff so I don't know if this matters nor the details for every cable. So the question is, is it possible that I can make a reliable extension for an USB 3.0 cable using regular UTP cable? will I experience some performance issues or something? Thank you.

Edit:

I am not planning to make extensions of more than 1.5m (~5ft) in length.

4
  • Why don't you just buy a UDB 3 extension cable? They are < 10$ from Amazon.
    – DavidPostill
    Jul 7, 2015 at 15:58
  • Because I can buy 1000ft of UTP and make as many extensions as I want for < $2 each, and I also have lots of UTP cable lying around here.
    – arielnmz
    Jul 7, 2015 at 16:01
  • Sure you can get the cable cheap, but do you also have a good source of USB3 connectors? Looks like you would spend at least ~$8 on the connectors+shipping. So I am not sure how you are going to make your cables for less than $2. BTW, this might be a better fit over on the electronics stackexchange.
    – Zoredache
    Jul 7, 2015 at 16:24
  • @arielnmz The cables are not compatible (see my answer).
    – DavidPostill
    Jul 7, 2015 at 16:30

1 Answer 1

4

Is it possible to make an extension for an USB 3.0 cable using regular UTP cable?

No, because the cables are not compatible:

  • Cat 5 cable contains 4 twisted pairs (8 wires) so it does not contain enough wires.

  • Cat 5 UTP has twisted pairs that are not shielded and only contain 8 wires.

  • Cat 5 STP has twisted pairs the are shielded and only contain 8 wires.

  • USB 3 cable requires 2 SDPS (Shielded Differential Pairs) each of which contain 3 wires.

  • USB 3.0 cables requires 10 wires:

    • Two wires are used for power.

    • A single unshielded twisted pair (UTP) is used for High-Speed and lower data transfer and allows for backward compatibility.

    • Two shielded differential pairs (SDPs) have been added. Each SDP contains three wires, two for signal transmission and one drain wire. The two SDPs are used for transferring SuperSpeed data allowing for simultaneous bi-directional data flow.

0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .