Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

Possible Duplicate:
Does increasing “Screen refresh rate” damage monitors?

I accidentally put the resolution of my screen to high and it caused my graphics driver to crash and had to reinstall my external display's driver again.

I wondered if putting the resolution too high can cause physical damage to the screen?

share|improve this question
    
superuser.com/questions/80843/… –  fretje Jan 15 '10 at 21:27
add comment

marked as duplicate by alex, Sathya, Jeff Atwood Jan 15 '10 at 23:29

This question has been asked before and already has an answer. If those answers do not fully address your question, please ask a new question.

2 Answers

up vote 3 down vote accepted

not the resolution but the refresh rate (if set too high) can cause damage to the display.

share|improve this answer
2  
Though, with some CRTs, you should watch out because the acceptable refresh rate goes down when you raise the resolution. For example, I have a display which can do 120hz at 320x240, but only 60hz at 1280x960. Technically, the limiting factor is the pixel clock, the number of pixels actually refreshed per second. –  marcusw Jan 15 '10 at 21:22
add comment

To a CRT, possibly. To an LCD, not as far as I've ever heard.

Edit: Broam and Molly are absolutely correct, inappropriate refresh rate is what can pop a CRT, not resolution (call to fork() failed). Still, AFAIK, neither will do anything to an LCD.

share|improve this answer
3  
Older CRT monitors could be damaged by a high refresh rate. More recent ones would have detect "out of range" refresh rates and refuse to display an image. –  Broam Jan 15 '10 at 21:00
3  
and it wasn't just high refresh rates that could damage them; it was any refresh rates that the monitor wasn't designed for. –  quack quixote Jan 15 '10 at 21:02
1  
Since refresh/resolution are just different variables in the same function, excessive resolution may result in an excessive refresh rate on a CRT, hence causing failure. So it's both right and wrong to say that refresh rate is all that matters. ;-) You could get away with higher than spec resolutions if the video card let you drop the refresh down low enough in some cases (43hz anyone? :-) ). As mentioned above too, LCDs are pretty much impervious. I've never run across one that you could push out of range. –  Brian Knoblauch Jan 15 '10 at 21:18
add comment

Not the answer you're looking for? Browse other questions tagged or ask your own question.