Take the 2-minute tour ×
Super User is a question and answer site for computer enthusiasts and power users. It's 100% free, no registration required.

I've configured ADSL and added new public LAN IPs for the router. How can I reconnect DSL connection and apply the new configuration without executing the command reload?

These are the commands I am using for DSL configuration:

 config terminal
 interface dialer 0
 ppp chap hostname User
 ppp chap password 0 Pass
 exit
 exit
 wr mem

and these are the commands I am using for adding IP addresses:

configure t
interface vlan 1
ip address xx.xx.xx.xx 255.255.255.252 Secondary
exit
wr mem

Thanks!

share|improve this question

migrated from stackoverflow.com Jan 18 '10 at 18:25

This question came from our site for professional and enthusiast programmers.

1 Answer 1

Just try shut / no shut on dialer port.

conf t
 interface dialer 0
  shut #may be wait few seconds after this
  no shut
end

And since this is not programming related, so, I am voting to close this (probably to superuser)

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.