2
votes
1answer
109 views

DD Wrt Wifi bridge connection breaking

I have a DD Wrt connected to a DD Wrt router as a Router - Client bridge setup. It works fine for sometime, but occasionally, it appears to stop communicating to the router, or internet.. not sure. ...
0
votes
0answers
1k views

Unable to get DD-WRT router set up as a Client Bridge to access the internet

I have a couple of network security cameras that use PoE and I would like to use them outdoors. The problem is that I do not have network ports anywhere outside, so the solution I came up with was to ...
2
votes
0answers
630 views

DD-WRT router causing IP address conflicts across network

My DD-WRT router has lost its mind! (Caveat: technically neither of these devices are "routing". I'm going to call them routers anyway.) I just set up two DD-WRT routers, one as a WAP (working fine) ...
2
votes
0answers
579 views

DD-WRT: Repeater bridge with VPN?

Setup: Router1 and Router2 run DD-WRT Cable modem is connected to WLAN port of Router1 Router2 runs in Repeater Bridge mode (there is also a separate SSID with virtual interface) This setup works ...
3
votes
2answers
683 views

Bridged Tomato network - problems with some devices on bridged wired segment

This is my network: Dotted lines indicate wireless connections, solid lines indicate Ethernet connections. I used two ASUS routers and Tomato to bridge my network. So I have have two wired ...
0
votes
1answer
928 views

Best performance between 2 Wifi AP (with DD-WRT)?

Typically when you search about distributing wifi with >1 AP there is a talk of WDS, however, WDS suffers 2 problems - speed (if I remember correctly maximum is "g" speed) and limit on distance ...
0
votes
1answer
239 views

WRT54g router with DD-WRT firmware

I have a WRT54G router with DD-WRT firmware and have it set up as a wireless bridge. Currently it is connected to my main router and then I have a computer in the garage that connects to the WRT54G. ...
0
votes
1answer
474 views

Second router on LAN is connected to other router via PPTP, but one network can't talk to the other

My ISP/Model router is set to 192.168.0.1 My DD-WRT is set to 192.168.0.80. A Linksys WRT300 that was flashed with a DD-WRT.BIN specifically for it (not the generic one). It uses the PPTP ...
0
votes
1answer
332 views

Boost strength of router using multiple router's network through WAN

I have D-Link dir-600 router with dd-wrt firmware. I have two more APs belonging to my neighbors. can I use these APs to boost my routers strength over WAN. I can have physical access to neighbors ...
2
votes
1answer
2k views

I want to use a secondary wireless router to connect to my primary, all wirelessly. Do I need a bridge, access point, or repeater?

I realize there is plenty of documentation on this subject throughout superuser and the internet overall. However, it's almost like there's too much information and I need help sorting through it. ...
1
vote
1answer
1k views

DD-WRT in bridge mode

I already have router which is Ubuntu PC. I need to connect my DD-WRT asus router WAN to Ubuntu routing PC in the way so DD-WRT will just bridge connection between wireless and WAN interfaces. Is it ...
1
vote
1answer
319 views

Wireless router can't be found from linux

I have a very strange problem with my wireless routers, or linux. I have 2 wireless routers one directly connected to my modem (router 1) and another wireless router (router 2) on the 2nd floor ...
2
votes
2answers
2k views

cannot ssh to computer behind a dd-wrt bridge

In my home network , i have dd-wrt router in another room , which bridges wifi from main home router (linksys) to the computers wired behind dd-wrt router. Now I cannot ssh from my laptop ( ...
2
votes
1answer
2k views

How do I disable auto-negotiation on DD-WRT?

I have a WRT54GL router with DD-WRT firmware installed, and have the exact same situation as exposed in this thread. The problem is, I don't know how to disable the auto-negotiation on the router ...
0
votes
1answer
177 views

DDWRT Bridge Question

I recently setup a bridge and I have a few questions. If the signal from router 1 is precieved as weak on the bridge router (router 2), what can I do to make the signal stronger? Condition: I do not ...