The tag has no usage guidance.

learn more… | top users | synonyms

0
votes
2answers
733 views

Wireless routers as Access point using LAN-LAN but no connectivity through other LAN ports, and wifi works

I have followed every single step given in following page of DD-WRT page to setup a wireless access point. http://www.dd-wrt.com/wiki/index.php/Wireless_Access_Point I have a belkin G router and a ...
3
votes
1answer
207 views

Connect internet camera and bridge/forward IP traffic

I have an Ubuntu (14.04) machine with two Ethernet cards. One Ethernet card (eth0) is connected to the office network. The machine is addressable from the outside Internet. I have a Web camera that ...
1
vote
1answer
119 views

Openwrt in bridge mode - ebtables kernel error

I have a setup at home as follow: DHCP clients -----> (wifi)(bridge) Openwrt -----> (eth)Main Router The device I'm using is TPlink MR3020 with Barrier Breaker and I tried to set up ...
1
vote
1answer
54 views

Would like to manage a DSL and Satellite Internet Connection

My parents live in the country and have very poor and unreliable DSL (Frontier) service. They are considering getting Satellite Internet (HughesNet or Exceed). Because the Satellite has monthly ...
1
vote
1answer
344 views

Speeding up Connection Between Computer and Wireless/Bridged Router

I looked through other questions, but didn't find useful responses. Our main computer has a dl speed of 6 Mbps, but some of our other computers are getting only 40-200 Kb! The router is wireless, ...
0
votes
1answer
28 views

kasda modem+ router 5212

I have kasda kb5212 (router + modem) and I'm trying to configure it to only modem but cannot understand how. I configured a PPPoE + added a bridge connection and disabled DHCP. may be I did ...
0
votes
1answer
29 views

How to connect entire network to VPN using RouterOS

What I have got : Mikrotik stx 5hpndr 2 And the other devices on the network.. I used to share my vpn connection on my laptop to other devices so I needed to move it around the house now ihave ...
0
votes
1answer
26 views

Unable to enable port forwarding on linksys router

I have a linksys BEFSR81 V3 router which I use along with an apple airport extreme. The apple airport is setup in bridged mode as seen here. On my actual router page, I have UPnP enabled as seen here. ...
0
votes
1answer
125 views

Low wifi speed after client bridge from G router to N router

I have a old belkin F5D7234-4 v5 G router and i wanted internet in two floors. So i bought a new TP-Link WR841N router. Even this router didnot provide propet signal in other floor. Used belking g ...
0
votes
1answer
404 views

Connecting 2 LANs via Wi-Fi

At my home I have a LAN with very fast internet (120Mbit/s). On my roof I installed a Wi-Fi access point to get good Wi-Fi around my house. About 200meters (600feet) from me a friend lives and I want ...
0
votes
1answer
662 views

eth1 ethernet adapter stopped loading in Ubuntu

I have had a working setup for 3 weeks which suddenly stopped working this morning. I can't identify what changed. I have two network interfaces on my main (Ubuntu 10.10) PC; eth0 is an ethernet card ...
2
votes
0answers
117 views

How to configure two broadband connection on the network so that if one goes down other can automatically start catering to Internet requests

Our earlier setup was 12 PCs connected via a switch. These PCs can connect to eachother via LAN. Broadband connection was via ADSL modem cum router plugged into the switch so that all PCs get internet ...
1
vote
0answers
62 views

(Resolved) Bridging networks issue

The architecture is: [ Router 1 ] [ Router 2 ] [ Router 3 ] [ aDSL Router ]---UtpCable---[wireless router]---UtpCable---[wireless router] [192.168.1.254] ...
1
vote
0answers
229 views

sharing Internet connection with 2 nic

OK I may not have done all the research but I see by virtualrouting.codeplex.com that it is possible... I am running into an issue. I have currently broadband access connecting to the wan port of my ...
1
vote
0answers
569 views

Multiple Access Points - Same SSID (Complicated Setup)

My current network utilizes WPA2-Enterprise as its authentication method. I am trying to extend my network further, but most wireless routers that I have found don't support repeating a WPA2-...
1
vote
0answers
655 views

How to wirelessly connect TP-LINK TL-WA701ND with a THOMSON TG585v7 router from the ISP?

How can I wirelessly connect a TP-LINK TL-WA701ND with a THOMSON router from my ISP? The THOMSON is connected to Internet and I want to connect to it TP-LINK. I tried do that using WDS on Thomson and ...
0
votes
0answers
7 views

Can an E900 wireless router in bridge mode, having IP on a different net than the bridged network, cause problems due to this config?

I have an ISP-provided router with one available wired port, and wireless. Because the router is placed in a bad spot in my apartment, I have connected a Cisco E900 wireless router with a cable. This ...
0
votes
0answers
8 views

Client can not take ip when ebtable rule is active

I've asked problem in this link before. https://forum.openwrt.org/viewtopic.php?pid=318612#p318612 I can get along this problem with taking all ipv4 packages to the network layer and new rule is ...
0
votes
0answers
49 views

how to access my Billion 7800VDOX router web UI after having configured it in bridge mode (modem)?

Unfortunately the ip address I usually use doeesn't work. No reference in the manual or whatever. The router is doing its job as a modem (connected to a router).
0
votes
0answers
360 views

Configuring MikroTik wireless pppoe with another router

There are too many problems with the xDSL and telephone line in my area so all xDSL providers ceased their service here. So my xDSL modem became useless. Then I contacted one of the best internet ...
0
votes
0answers
268 views

How to bridge Wi-Fi Reciver and ADSL Modem so that I even can share the net connection with the WiFI device and second router?

I have an ADSL modem which has an active internet connection. Then I have Wi-Fi Receiver/Emitter and another ADSL Modem. A: 1st ADSL Modem with active internet connection B: Wifi Modem[Receiving ...
0
votes
0answers
172 views

Setting up second router

Background: I recently moved in with my girlfriend and the only option she has for broadband is ATT DSL and the router she must use is not the best. It is a Netgear model B90-755025-15 The wifi ...
0
votes
0answers
1k views

How do i properly configure Bridge Mode on a modem/router?

Just ordered a modem from a local ISP. When i switch the device to Bridge mode and connect it to my router, i cannot no longer connect to the Internet. On the management page of the modem/router (from ...
0
votes
0answers
260 views

Use my own router if ISP supplid does not support bridge

I have a Technicolor TC7200 I am getting sick of. I'd like to get my own router, slap OpenWRT on it and control my LAN myself. Also, I'd like to have more control over my wireless. The Technicolor ...
0
votes
0answers
132 views

Port Forwarding issue after Bridging

TWC Roadrunner has provided us with Motorola SBG6580 Router/modem I bought my own router Netgear WRN2000v2 running DD-WRT firmware.. i plan on using the netgear as my only router and dont wanna go ...