0
votes
0answers
5 views

Zyxel P660H-D1 Bridge without Default Gateway (N/A)

can someone help me? i have a configuration from old Modems, and i wanna configure new one, as same. The Config must be so: Bridging! WAN Information - DSL Mode: NORMAL - IP Address: N/A - IP ...
0
votes
0answers
30 views

Configure router as a plain modem

I have a wired D-Link router DSL-2520U, which is a ADSL2 router. I think it has a modem built into it so i can just connect my PC directly to it and connect to the internet via PPPoE I also have ...
2
votes
3answers
15k views

Setting D-Link Modem in “Bridge mode”

I am trying to extend the wireless network in my house. I have a cable modem attached to a D-Link DIR-635 wireless router. This works fine if I am in the part of the house near the router. I have ...
0
votes
2answers
2k views

Accessing Tomato router in bridging mode?

I've flashed my Linksys WRT54GL router with the Tomato 1.28 firmware. This has worked fine, and I set its IP address to 192.168.1.2. I already had a wireless router, but the reason I bought this ...
0
votes
1answer
255 views

Need to extend my 802.11 G signal

I have a cable modem hooked to a D-Link DIR-628 that we use as a wireless router for a mix of Apple Macintosh and HP Windows 7 computers in our home. The home is over 5000 square feet and the D-Link ...
0
votes
2answers
2k views

Can I use my WRT54G instead of my ISP's cable modem?

My ISP has provided a crappy Thomson cable modem with 4 LAN ports and wifi, which constantly crashes and reboots itself. I am going to ask for a replacement, but here is my question: --> I have a ...