0
votes
1answer
112 views

Values below “Starting IP address” in linksys router.

In my basics setup in linksys router, I've set Starting IP address to 192.168.1.100. How can you explain that in ARP/RARP Table I can see users with addresses 192.168.1.25 and 192.168.1.26?
1
vote
1answer
95 views

Cannot access a very specific site from my router

This is a problem for me because this site is important to me. It's MY website. And sadly my email is hosted on my site (which I cant access either) When I try to access my website when connected ...
-1
votes
1answer
73 views

How do I raise the ping of one of my ports on my Linksys Cisco WRT160N v2 Router?

I'm a real newbie when it comes to computers, internet, networking, etc. but I'm an avid gamer. And I play a game (on my PS3) which plays best at a higher pings (slower speeds) for some reason beyond ...
0
votes
2answers
165 views

Planning home network

I'm planning to setup my home network from scratch and want to ask professional opinions or tips. My home is connected to Internet with a cable connection (100 Mb/s). The devices I would like to ...
0
votes
1answer
528 views

Can't completely reset Linksys E1200

I purchased a Cisco Linksys E1200 router, and I opted out of the Cisco Connect software. Once I did that, I was able to set the WPA2 password. Now, when I go to log in to the administration area of ...
1
vote
2answers
6k views

Can't connect to Linksys E2000 router admin interface: Connection refused

I am trying to connect to our router on 192.168.1.1 (correct IP) directly plugged in via Ethernet cable. Connection via Firefox simply gives the can't establish a connection to the server error. ...
3
votes
2answers
177 views

Can we install 2 access points on the same network with different SSID?

I have a network over 2 floors. i had 1 access point on the top floor and need to put another on the bottom floor but with different SSID & password. can it be possible.. Please Help.. Thanks in ...
0
votes
0answers
438 views

Linksys e3200 connectivity issue (most likely DHCP server configuration)

I have a Linksys E3200 router with a connectivity problem. The router doesn't allow the creation of connections for some reason. I can get the SSID of my wireless networks but when I try to connect ...
0
votes
0answers
62 views

How to access the router log for given dates

How do you access and print the router log for given dates from a Cisco / Linksys wireless router? We need the October 1-2, 2011 log entries to fight an uploading allegation. Thanks.
0
votes
1answer
3k views

Need advice on setting up a wireless bridge, both having wireless PCs, without using a repeater?

I wish to setup a wireless bridge between two routers, both of which will have wireless clients; however, I want to do this without using a repeater. I would prefer not to have the bandwidth halved. ...
0
votes
1answer
4k views

How to set a 5 char (40 bit) ASCII password for WEP on a Linksys v8 device

I have a Linksys FW v8, and I want to use wireless password "12345" for WEP. I cant set it up, I just can specify a 64 or 128 bit, I want 40 bit, 5 char long. Is it possible?
0
votes
1answer
139 views

Could this wireless set up cause this issue?

I have two routers hooked up to a DSL modem. The first is an older Linksys wired router(might be BEFSR41) and the other is a newer Cisco Valet M20. The valet was added on recently to enable WiFi ...
2
votes
3answers
6k views

Reset gargoyle router to default

I have a Linksys WRT54GL router with gargoyle installed. Unfortunately, I've forgotten my password so now I'm trying to reset it. I've already tried the 30/30/30 hard reset method, but it didn't ...
1
vote
2answers
35k views

How do I set up a simple VPN on a Linksys RV042?

The documentation on the internet has been less-than-helpful, and the management interface is not very straight-forward for people who don't know all the VPN jargon. I just want to be able to open ...
0
votes
1answer
333 views

Linksys gateway unable to set static IP of my PC

I got a Linksys gateway WAG54G2 and there is a problem, that I can't find in the gateway web-configuration how to set static IP for my PC using cable connection. Firmware Version:V1.00.10
4
votes
2answers
962 views

Losing 1/3 of my download speed with my new router, any ideas on how to fix?

I recently replaced a dying D-Link router with a Cisco/Linksys RSV4000. I'm really happy with the device but it seems when my cable modem is plugged in to it I lose 1/3 of my download speed. When I ...