The tag has no usage guidance.

learn more… | top users | synonyms (1)

0
votes
2answers
88 views

Dynamic DNS service allowing to define the IP address

Is there a dynamic DNS service that allows you to specify the IP address to point to (instead of pointing to the IP address making the request)? We use dynamic DNS in our mobile application ...
0
votes
1answer
504 views

Running my own dynamic DNS service

I am planning to build my own little dynamic DNS service for my home server. I have a domain hosted by a provider who provides a web interface to create and edit nameserver record. This domain has an ...
1
vote
1answer
629 views

site to site vpn between peers, all with dynamic ip?

How do I set up a site-to-site VPN between 2-6 sites, when all the peers are using dynamic IP? DynDNS (or equivalent) is set up on all sites, so accessing the IP from outside shouldn't be a problem. I'...
0
votes
0answers
112 views

Access home server from same network

I have a old home PC on which I host some private git repos. I push/pull using ssh, which I set up on port 54345. I also set up a dynamic DNS server (similar do dyndns.org) for accessing the PC from ...
1
vote
0answers
425 views

Dynamic DNS with tunnel/proxy to the public?

TL;DR: I want to be able to access my laptop publicly from anywhere, while my laptop could also be anywhere. Any Service, any port. Original Post: I want to be able to access my own computer from a ...
-1
votes
1answer
159 views

Dynamic DNS update server DNS Host

Could I use dynamic DNS server to update Primary DNS and Secondary DNS settings on router? My TCP/IP settings are: IP address: 123.43.23.11/24 Default Gateway: 123.43.23.1 Primary DNS: 195.67.19.3 (...
1
vote
1answer
5k views

Which IP address do I enter at dlinkddns.com?

I am trying to set up DDNS in my router to enable a static IP address. Standard procedure, should not be a hassle really, but I am facing troubles at dlinkddns.com. Which "New IP address" does it want ...
0
votes
1answer
180 views

Internet not working after configuring server for DNS with dyndns

Objective to be achieved: To access the server using a name server.xyz.com. I've a domain xyz.com and a server behind a router. Also, I've configured my server with dyndns. On executing the ...
0
votes
1answer
2k views

How can I configure dyndns service in dlink DIR-600L router to access my local server via internet?

The following link is the graphical representation of the networking done in my home. I have a DLINK DIR-600L Wireless router which is connected to modem via a switch. As this router have DDNS ...
0
votes
1answer
705 views

How to configure ddclient to refresh every 30 days?

Can ddclient be configured in /etc/ddclient.conf, to send dynamic DNS updates periodically, in addition to when the IP address changes? Why? Fremium provider dyndns requires an update be made every ...
0
votes
1answer
314 views

Updating iptables via ddclient

TL;DR Is there anything I can do to change iptables from ddclient (with user ddclient)? The story behind I have a computer that uses dyndns to be addressable from outside. Whenever the provider ...
1
vote
0answers
367 views

DNS fallback from VPN-provided DNS

I have a local DNS server that tracks all of my machines in my house, provides caching from the internet on commonly-used look-ups, etc. I'd like to use that to cache both the internet and the DNS ...
0
votes
1answer
3k views

How to redirect Dynamic DNS to a specific local ip address?

I'm trying to remotely access a specific computer from my LAN on which i'd like to run a webserver. My network router is a Pirelli A226G router. I've set up a Dynamic dns account, and it works: if i ...
1
vote
0answers
846 views

No-IP on Linux: What am I doing wrong?

I want to setup a small home server using Fedora 17 (32 Bit) and No-ip because I have a Dynamic IP adress, This is what am I doing: 1) I create a Host on No-ip: 2) I setup No-ip on my fedora box: ...
1
vote
1answer
1k views

How to share Twonky 7 library (running in NAS) over internet?

The problem: I had funplug & Twonky Server 7 running on my Dlink DNS320 (guide: http://nas-tweaks.net/384/installation-of-twonky-server-7-on-nas-devices/) Now I want to share my Twonky library ...
1
vote
2answers
154 views

Home hosting using no-ip

I have a dynamic host from no-ip witch gets updated with my ip address,the webserver works ok. I also have a domain name registered, and I want to resolve to this dynamic host. If I run a DNS server ...
-1
votes
2answers
2k views

make DD-WRT send its public IP to an email address

Is it possible to setup DD-WRT (router firmware family) to send out its IP somewhere? Periodically, or preferably, whenever it just changed? I am not ready to set up (and pay for) dynamic DNS yet, ...
1
vote
3answers
480 views

Unable to resolve dynamic IP for home web server

I have configured my home web server with Fedora. Now if I enter localhost or 192.168.0.1 in my address bar I can see the Apache test page. But if I enter my current dynamic ip on address bar then I ...
0
votes
3answers
346 views

Is router compulsory to host a server at my home PC

I know the requirements for hosting though I have a doubt whether router is really needed? Compulsory things are access to the Internet, a web server, static IP (I will use dynamic DNS services like ...
1
vote
1answer
195 views

DynDNS configuration - second to last packet is timed out during tracert

I have a NAS in a separate location which I connect into through a DynDNS domain I got for it. When I tracert to that DynDNS name, the following comes up: 1 3 ms 2 ms <1 ms ...
0
votes
1answer
412 views

Windows 8 Pro Remote Desktop issue

I have a weird issue here. I'm running Windows 8 Pro. The client computer is also running Windows 8 Pro. Remote Desktop works when I'm in the same network. I tried connecting using my external IP ...
0
votes
2answers
1k views

DHCP not updating DNS

RHEL5.6, bind-9.3.6, and dhcp-3.0.5 So, after I fixed my problem with getting DHCP to parse the MAC addresses for these virtual machines, now I need to figure out how to get it to update DNS when one ...
1
vote
1answer
159 views

Can't connect to router behind other router from outside

I have the following setup: Internet ⟷ ADSL internet router ⟷ TP-LINK wireless router I want to access this TP-LINK router through the internet. I've tried to access it by DynDNS or No-IP, but I ...
1
vote
0answers
457 views

How to route a global url to a local computer on a Fritzbox

I have this Linux server in my LAN, which can be reached from anywhere using dyndns services. So when I am out, I enter myserver.dyndns.org to get to it. When I am at home, I could do that too, but ...
3
votes
2answers
478 views

Domain resolving to lan ip address under dynamic dns and tomato

I have recently begun hosting my personal website under a home server using dynamic dns. The domain is registered under Godaddy, and ZoneEdit as the dynamic dns manager. Everything works well till it ...
9
votes
1answer
11k views

Access my computer externally without port forwarding

I have a linux machine (Sabayon 13 KDE) that I'd like to be able to access remotely for SSH, FTP, HTTP, and so forth. I signed up for Dynamic DNS with No-IP.com, but this isn't adequate because I am ...
0
votes
1answer
616 views

Setting up dynamic DNS for linked router

I have a 'main' router that receives the internet signal from the ISP and another one in my room, connected with a cable. The main router is running its original firmware and is very limited in its ...
0
votes
1answer
291 views

Trouble configuring local network to work with DynDns.org

I have a Westell 7500 modem/router (two actually) from Frontier. It is setup in bridge mode, passing through to a Cisco RV042 load-balancing router. The Cisco is setup to update DynDns for my domain, ...
1
vote
1answer
80 views

Will upgrading my home connection actually give me better speeds through WebDav?

I currently have a Synology ds411 NAS hard drive with 4x2TB hard drives in RAID 10 (so 4tb usable) and I'm about to get a job which requires a lot of travel away from home. I connect to the NAS over ...
1
vote
1answer
157 views

MAC OSX as server cannot be seen by dyndns address - router is blocking access

I have OSX running an RTC rational team concert essentially a Tomcat server on https port 9443. In the OSX host file I have 127.0.0.1 mapped to thinkbigapps.dyndns.tv - such that On the mac i can in ...
9
votes
3answers
5k views

How does DynamicDNS act immediately?

My understanding of the core functionality of DNS is to provide a naming/mapping service between domain names (e.g. blah-whatever.com) and IP addresses (e.g. 100.2.3.4). Furthermore, my understanding ...
0
votes
1answer
916 views

How to have url rewrite to a specific port on Mac OS X server behind DD-WRT router?

I've just setup a home web server using Mac OS X Lion's built-in Apache server. I setup access my Subsonic music server running on port 4040 and my torrent remote control on port 9091, as well as the ...
0
votes
2answers
1k views

Make dhcp assign same IP and hostname for different interfaces at one machine

I have a feeling that question itself looks stupid but it is not. Please let me clarify. I have dynamic DNS with BIND and NIS configured at my LAN and have laptop which I am using in both wireless ...
4
votes
1answer
14k views

How can I configure a “global hostname” in Airport Utility?

AirPort Utility 5.6.1 for Windows disallows entering dots ('.') in the global hostname. Whenever you try to enter a '.', it just beeps with an error. Setting a global hostname is the AirPort way ...
1
vote
1answer
5k views

Good dynamic dns service and client for mac server in 2012? [closed]

Apparently DynDNS does not offer free dynamic DNS anymore. My router does ONLY support DynDNS and there is no 3rd-party firmware to change this. I am searching for an alternative for my requirements,...
1
vote
4answers
4k views

Can I manage my own domain using a web sever at home without having a static IP address using NO-IP?

I have purchased my own domain in GoDaddy. I have a server at home, Windows Server 2008 R2 to be specific. I do not have a static IP address, however I have created an account in No-IP, have the DUC ...
18
votes
4answers
8k views

Services that just return your public IP as text [closed]

I'm writing a script that does dynamic DNS updates for me, but my server is behind a router, and so I need to use a web service to determine my public IP. So far I've found this one which returns ...
0
votes
1answer
664 views

How do I set up my home server to go directly to a port other than 80

I'm using dyndns, a lynksis wt54g router, and tomcat 7 with spring to set up a web server. This is my first time to attempt this. I'm sure this is a very common question, but I don't know enough to ...
0
votes
1answer
180 views

Multiple servers (in different locations) with single domain

I have a VPS located in another part of the world that has a static IP. I also have a server at home which has a dynamic IP. Right now, I'm using No-IP's dynamic DNS client to update my home server's ...
0
votes
2answers
2k views

Dynamic DNS, connect subdomain to internal NAS and laptop

I have no idea if this is a valid question on these boards but, the community seems so bright here so I'll ask anyway. I'm tryin gto setup the followign at home. 1) File server via my Western ...
2
votes
1answer
797 views

Hosting dynamic DNS website on Virtual Box with single open port - safe?

I am looking to host a website on my own machine at home with something like dynamic DNS purely to demonstrate it to a some friends for a few days over my ADSL connection. On my LAN are a few precious ...
2
votes
2answers
854 views

Redirect Apache SSL traffic to subdomain with a proper certificate

I currently have a server which has a DynDNS subdomain (let's call it foo.dyn.com). I also have a proper domain with a CNAME pointing to that subdomain (let's call it bar.baz.com). foo.dyn.com has a ...
2
votes
1answer
311 views

Dynamic DNS for the domain root

I have a host set up with Dyn, and the IP address for this host is dynamically updated by my router. My domain's DNS is delegated to Dyn, and I've set up subdomain CNAME records which alias the host, ...
5
votes
2answers
7k views

ddclient updating to local IP instead of public IP

I'm trying to setup ddclient on my ubuntu server to update my DNS records on zoneedit for when my public IP changes. It's updating fine, the problem is that it's giving zoneedit my local IP instead ...
1
vote
0answers
404 views

Remote Desktop Connection Randomly Stopped Connecting to Windows 7 Ultimate x64

I have allowed remote desktop connections on my home machine: Windows 7 x64 Ultimate. Fixed IPV4 set via LAN (in network adapter settings). Router is set to forward port 3389 to my fixed IP (192....
1
vote
2answers
5k views

Can DynDNS work without port forwarding behind firewall?

Here's the scenario: I have a Mac with a web server running. I frequently travel with this Mac and often times, I am at locations where DynDNS would not work, since the client site admin does not ...
0
votes
0answers
531 views

Unable to link No-IP to my website that is hosted on a VBox machine

I have a webserver running on a virtual platform (VBox). Have set the VBox adapter to bridged mode. I am able to access the webpage from my host machine. I have also configured dynamic DNS (No-IP) on ...
1
vote
3answers
1k views

Should I use a static IP address? If so what kind?

Last night I managed to get my local PC running as a server using port 80 and my IP address. After restarting my machine it stopped working. I was told I need to make a static IP address. My ...
1
vote
1answer
112 views

Does it make a difference if I specify IP or domain name with a local server?

I have a computer in my house set up at, say <domname>.dyndns.org, it also has a local IP of 192.168.1.101. Is it consistently faster to use <domname>.dyndns.org or the IP for SSH (when ...
0
votes
2answers
4k views

What could be blocking my DynDNS?

I made an account on DynDNS and with my new router (Zyxel) I can't seem to connect to it. I want to be able to connect to my router when I am somewhere else in the world – just like I can connect to ...