3
votes
2answers
137 views

Why is tracert showing a private IP address right after my router, even though it has a public IP?

Here is a log of tracert superuser.com from my computer: Tracing route to superuser.com [198.252.206.16] over a maximum of 30 hops: 1 2 ms 2 ms 2 ms 192.168.1.1 2 11 ms 17 ...
2
votes
1answer
117 views

static IP outside of subnet range

I have two questions, but let me explain the situation first. They are about the (static) IP address of a printer attached to the network. We had this networking setup, using a normal consumer router ...
5
votes
1answer
537 views

Exactly how many valid IPv4 addresses are there?

Seemingly simple question, with enough edge and corner cases that I don't trust my ability to calculate it. What is the exact number of valid IPv4 addresses that could potentially be used as ...
1
vote
1answer
125 views

LAN and WLAN networks under same IP range

I'm a newbie in network stuff and haven't enough knowledge to do what I'm wanting for now, so I need your help, please. I've two networks, a wired and another wireless. The wired one is between two ...
2
votes
2answers
420 views

Doubt In default time to live (TTL) 255?

I know that,The Default Time to live value is 255, each time a ipv4 packet crosses a router that value is decremented by 1. But,When I ping my adsl router it shows TTL as 64 Pinging 192.168.0.1 ...
0
votes
2answers
50 views

Ways to differentiate between home and office private network

Let us consider there are two networks 1) home network and 2) office network. I have an application which will get the system IP and MAC Address of the installed machine while launching the ...
3
votes
2answers
116 views

How does the separation between IP addresses on the internet and on the LAN work?

Complete newbie question: Say for example the address: 8.8.8.8 How does the computer know that this address is on the internet, not the local network? Could a device on the local network have the ...
0
votes
1answer
238 views

How to route to public IP addresses from NAT where gateway is in subnet of target public ip addresses

I have the following scenario which is giving me fits. I have a block of IP addresses on a .248 subnet. The service is Comcast, and the modem uses IP addres ending in .246. On the router for my ...
0
votes
2answers
418 views

IPv6 connection through IPv4 network without internet-connection

I'm working at a project at my university and now the following problem shows up: We got a Server [Server] with a private IPv6 network. Some sensors (temperature, humidity...) are connected through a ...
0
votes
2answers
128 views

Network Redirect off subnet for Synergy in hosts file

Perhaps I'm off the right track here, but I'll describe what I'm trying to do first generalized and then why I want to do it. General Case I'm looking to redirect a specific IP address on a single ...
1
vote
1answer
116 views

IP Routes - Route Mapping

I've been reading up on static routes and such while studying for my next MS exam, and am wondering - in CMD, if you do a route print -4 you get a Active Route Output such like this: Destination ...
2
votes
2answers
567 views

How does CIDR slow the exhaustion of IPv4?

In the Wikipedia article on CIDR, it says The Internet Engineering Task Force introduced CIDR in 1993 to replace the previous addressing architecture of classful network design in the ...