0
votes
1answer
66 views

Limited WAN speed through Linksys E4200 running DD-WRT

Today we have upgraded our internet connection from 90 Mbps to 180 Mbps, only to find out speedtest.net will not give a result higher than ~96 Mbps. If I connect directly to the modem, bypassing the ...
2
votes
1answer
89 views

Configure DD-WRT router behind a Cisco cable modem

I have a Linksys WRT54GS router flashed with DD-WRT that I'm trying to get a connection on behind a Cisco DPC3010 cable modem. I can get a connection just fine when I plug my computer in directly ...
1
vote
0answers
44 views

Router slowing down to a crawl

Recently I upgraded my 2Mbps ADSL connection to a 6Mbps ADSL2+. Ever since this has been happening: After a router reset, the connection from modem to router is at a speed of 6Mbps for around 15 ...
1
vote
1answer
94 views

Will the dd-wrt Big build run on my Linksys WRT54GL?

I have a Linksys WRT54GL access point acting as a NAT router, with the inside network being my house's wireless and the outside network being a point-to-point link to my DSL gateway. My ISP is Telmex ...
1
vote
0answers
208 views

Unable to use a chromecast with a WRT160N router running DD-WRT

A few days ago I bought a Chromecast. I did the setup using my phone and it works great when using my phone, tablet or a wifi computer to cast stuff to it but I can't use it from my desktop PC which ...
0
votes
0answers
93 views

Failed to upgrade to a newer version in DD-WRT on my Linksys Wap54g. What now?

I failed to upgrade to a newer version in DD-WRT on my Linksys Wap54g through Web Interface. The first upgrade from Linksys to DD-WRT through "TFTP client" was successful. Now again uploading DD-WRT ...
0
votes
1answer
2k views

Linksys WRT54GS - where to get old firmware v4.70.6

I've just bought a second-hand Linksys WRT54GS (v4) with intention to put DD-WRT on it. Unfortunately, I have problem with software currently running on this device. It has Sputnik based on firmware ...
3
votes
1answer
872 views

WiFi speeds half of wired speed

I just upgraded my Comcast internet, and my wired speeds vary from 58 Mbps to 70 Mbps (per speedtest.net). I have a WRT610N router, and I'm only getting around 20-25 mbps from the wifi. Things I ...
1
vote
2answers
978 views

DD-WRT SSH Setup

Okay so I installed DD-WRT firmware onto my Linksys E2000. I can see my dd-wrt page and everything but I am having trouble setting up ssh usage. I tried following these instructions. But after all ...
1
vote
0answers
315 views

barebones features for a DD-WRT router acting as PPTP server

I have a little router (Linksys E900) only to act as a VPN server. I have a decent router behind it, handling radio anyway. So I am happy to relegate any other CPU-intensive stuff to the bigger ...
0
votes
1answer
454 views

Port forward list is empty in DD-WRT

Router: Linksys WRT-54G-TM DD-WRT Version: DD-WRT v24-sp2 (08/12/10) mega When I go to NAT/ QoS => Port Forwarding, the list is empty. I previously had port forwards set there, and they are still ...
5
votes
3answers
4k views

Is 50% download speed on a wireless G network normal?

I have a wired connection of about 36Mb/s, but my wireless speed is max at about 18-19Mb/s. I have a WRT54G-TM (T-Mobile, 802.11G) router with DD-WRT firmware - I've upgraded it to latest build. Done ...
4
votes
1answer
787 views

Can interference cause lost Wifi signal?

I have a strange situation. I have two Linksys WRT54G routers running DD-WRT. Both routers suddenly started acting strangely yesterday. Loss of signal, couldn't connect to the router, once connected, ...
4
votes
1answer
486 views

I am looking to expand my Wi-Fi range using two Linksys routers. How do I go about this?

Most of the computers in the house are used up to a maximum of five or six feet of the router. However, my iPad cannot get a good signal through a couple of walls. Here's what I have: Linksys ...
1
vote
1answer
2k views

DD-WRT DNS lookup failure

I'm trying to configure a new router (a Linksys WRT160Nv3) with DD-WRT. It seems that no matter what the settings, DNS lookups fail. I can't ping anything outside my network (I get an unknown host ...
2
votes
5answers
27k views

How to find the static ip address of my router?

I bricked my Linksys WRT54GS router when trying to change the firmware on it from dd-wrt to open-wrt. In order to unbrick it, I need to be able to do an ftp transfer to it. The problem is that it ...
1
vote
3answers
920 views

Slow connection on WRT160N or WRT54G

I have a WRT160N V3. I'm getting 10Mbps from the wired connection and when I bypass it I get 18Mbps (what I pay for). The strange thing is that when I update the firmware or reset configurations it ...
2
votes
0answers
944 views

How to setup “all traffic” VPN on Linksys WRT54GL (DD-WRT) through Thomson ADSL Router

[Apols if I get terminology wrong...n00b to this!] I have a (pretty unconfigurable) ISP provided Thomson ADSL router - ISP runs PPPoE. I added to this a Linksys WRT54GL router which I want to keep ...
1
vote
2answers
18k views

How do I revert back to official Linksys firmware from dd-wrt on WRT56G2 v1?

I've been having trouble with dd-wrt on my Linksys WRT56G2 v1 router and want to go back to the stock Linksys firmware for it. The router has only 2MB of flash memory, and so I'm running the 'micro' ...
2
votes
1answer
846 views

Enabling IPv6 support on a Linksys WRT400N router

I chatted with a Linksys support person and they said that the WRT400N doesn't have any facility for enabling IPv6. If I were to use an alternate firmware on the router, would IPv6 become available ...
2
votes
1answer
2k views

Running a LinkSys WRT400N router with 3rd party firmware

Does anyone have any experience with the LinkSys WRT400N router and installing 3rd party firmware on it? Is there a more stable choice between DD-WRT and Tomato? Any benefits one way or the other? ...
0
votes
1answer
479 views

Second router on LAN is connected to other router via PPTP, but one network can't talk to the other

My ISP/Model router is set to 192.168.0.1 My DD-WRT is set to 192.168.0.80. A Linksys WRT300 that was flashed with a DD-WRT.BIN specifically for it (not the generic one). It uses the PPTP ...
1
vote
2answers
7k views

WRT610N v2 with DD-WRT: How do I configure wireless for dual channel (N 300MHz)?

I bought a Linksys router WRT610N v2 and I installed DD-WRT build 14896 preSP2 on it. I bought a Linksys Dual Bank Wireless N adapter for my laptop. I have no idea how to configure the router for ...
1
vote
1answer
5k views

Factory reset on a DDWRT hacked router

I installed DDWRT on a linksys router and changed the default ip for the admin login. I'm trying to get back into the router but forgot what ip I changed it to. What would happen if I were to try to ...
2
votes
2answers
13k views

How do I set up a second 5GHz N-Only network with DD-WRT?

I have a Linksys WRT610N v2 running DD-WRT v24-sp2 (mega) - build 14896. I'm trying to set up two access points on the device. One 802.11g network for most of the computers and wireless devices in my ...
0
votes
1answer
235 views

linksys wrt54gl dead [closed]

I have a linksys wrt54gl rev 1.1. I tried to flash the firmware to dd-wrt,and the firmware installation failed. Now i am left with a router that has the power led blinking and no connectivity via LAN. ...
1
vote
2answers
2k views

Linksys WRT54G2, what revision is this router?

I would like to put DD-WRT on my router (Linksys WRT54G2) but the website says that the latest revision 4 (I think) isn't supported. How do I check what revision router I have? Thanks much
0
votes
1answer
388 views

Linksys WRT150n: how to migrate from Sveasoft to DD-WRT?

Since I started using multiple laptops with 802.11n, my WRT150n periodically loses wireless capability and I have bounce the box to regain wireless. Before getting a new router, I wanted to try ...
3
votes
1answer
5k views

Assign IP's to certian mac addresses in dd-wrt

I have a Linksys WRT54G/GL/GS that I am running DD-WRT v24-sp2 (10/10/09) vpn - build 13064 on it and for the life of me I can not find a way to assign ip's based on Mac address. Basically I have a ...
1
vote
1answer
1k views

LinkSys WRT54GL + AM200 in half-bridge mode - Setup guide recommendations?

I am basically looking for a good guide on how to set up my home network with this set of hardware. I need: Dynamic DNS Firewall + port-forwarding VPN Wake-on-LAN from outside firewall VOIP would ...
0
votes
2answers
619 views

Setting up a router as a DNS server only

I have a Linksys WRT54GL router that I don't need anymore, since I had to buy a 3G capable router (Dovado 3GN). As I only have a 3G connection at home, I want to optimize it as much as possible. I ...
0
votes
3answers
3k views

DD-WRT Linksys WRT320N Max Tx Power

What is the save max Tx Power setting for WRT320N in DD-WRT?
2
votes
1answer
2k views

How do I disable auto-negotiation on DD-WRT?

I have a WRT54GL router with DD-WRT firmware installed, and have the exact same situation as exposed in this thread. The problem is, I don't know how to disable the auto-negotiation on the router ...
1
vote
1answer
709 views

linksys WRT350N dd-wrt: how can i give upload priority to slingbox?

i have the router WRT350N by Linksys I've installed dd-wrt v2.4 sp1 on it how can i configure it to give upload priority to slingbox ? The Slingbox is a TV streaming device that enables users to ...
1
vote
2answers
3k views

dd-wrt v24sp2 std. on WRT54GL v1.1 - remote access do not work (neither ssh not web-interface)

After installing the standard version of dd-wrt v24 sp2, I lost the ability to remote-access the router. The sshd is running and remote ssh is enabled. I can ssh into the router from the LAN, and ...