3
votes
1answer
110 views

RAID-1 causes far more noise than non-RAID?

After moving two 2 WD 1TB Black drives to a hardware RAID-1 system on my GA-Z87X-UD3H Gigabyte motherboard they started making a lot of noise and rattle. I've tested both of them separately in a ...
0
votes
1answer
2k views

Can I pull one HDD from RAID1 and still use 2-bay QNAP NAS?

I have a QNAP TS-239 Pro II+ with 2 x 2 TB HDDs in RAID1. I'm running 3.6.0 Build0210 firmware. I access the NAS from my iMac (OS X 10.7.x). The NAS HDDs are formatted as ext4. I'm sitting at about ...
1
vote
0answers
152 views

Will Thermaltake Muse R-Duo Raid reset lose data?

I have a Thermaltake Muse R-Duo Raid chassis with two drives installed and DIP switches set to Raid-1. However, only the left lights are lighting up and I have data on the drive. I'm guessing it is ...
-1
votes
1answer
509 views

RAID with pen-drives, it is possible?

Can Windows 7 manage 2 or more pen-drives (or external disk drives) to implement a RAID-1 to backup the content of them? I have a pen-drive and an external hard disk, both with really relevant and ...
2
votes
3answers
5k views

How can I move RAID 1 hard drives from one enclosure to another or retrieve the data another way?

I have a Fantom G-Force Mega Disk MDN 1000 dual drive hard drive enclosure with two 500 MB hard drives setup in RAID 1 mirroring mode. Unfortunately, the enclosure/controller has failed, for the ...
0
votes
2answers
2k views

Is it better to buy a 4TB RAID 1 hard drive, or 2 hard drives with 2TB each, and just use SyncToy (or invest more and buy a RAID 5 drive)?

Somebody said that with a RAID 1 drive, 4TB will be 2TB of storage, but if the controller goes bad, then the whole drive will go bad -- unless WD can send you a new enclosure? (stated in ...