2
votes
1answer
134 views

DD Wrt Wifi bridge connection breaking

I have a DD Wrt connected to a DD Wrt router as a Router - Client bridge setup. It works fine for sometime, but occasionally, it appears to stop communicating to the router, or internet.. not sure. ...
0
votes
0answers
37 views

Home router/bridge connection problems

At home I have a Dlink DAP-1525 Wi-Fi extender which I have been using as a bridge to my desktop. The extender and the desktop are located in my office and they are connected via an Ethernet cable. ...
0
votes
2answers
43 views

How to call something between a bridge and a router?

A proper router: Different IP subnetworks each sides; Sends packets from single MAC address; Does not require promiscuous mode; Broadcasts are not usually propogated; Maintains table of IP-MAC ...
0
votes
1answer
42 views

Is wireless bridge gives the ip on same subnet

I have got one server which i want to put in garage but i can't get the any LAN cable from router to that server. so someone told me to use wireless bridge. I am thinking fo getting this one i ...
0
votes
0answers
77 views

Improve LAN performance with bridging modem

I have ZTE ZXHN H208N ADSL modem that works in routing mode in our LAN. Because of poor performance, I have put it in bridge mode with Mikrotik RouterBOARD 493 and that worked (I had internet access), ...
1
vote
1answer
2k views

How to configure a TP-Link N600 to act as a repeater

I have a router TP-LINK N600 (TD-W8980) and an Alcatel Y800 (Mobile WiFi device with a 4G SIM inside) The Y800 is connected to the internet (and any device can connect wirelessly to it and get ...
0
votes
2answers
116 views

Can the number of connections on my 2ndary router slow down my internet access on my primary router? [duplicate]

I previously used a modem/router that Verizon mailed to us when we signed up as our sole internet hub, but I've been experiencing strange/intermittent/slow internet speeds (almost always around ...
-1
votes
1answer
653 views

Disable NAT/bridge LAN to router's network

I'm at a third world country, connected to a neighborhood ISP (an ISP that serves neighboring neighborhoods) and they have some "value-added services" where they have FTP servers and Windows shares on ...
0
votes
0answers
649 views

Using my TL-WR1043ND router as a Wireless Bridge AP - Get no IP on it

I want to use this setup: -- Cable connection ~~ Wireless connection Internet--WNDR3700~~TL-WR1043ND--PC ...
1
vote
0answers
103 views

sharing Internet connection with 2 nic

OK I may not have done all the research but I see by virtualrouting.codeplex.com that it is possible... I am running into an issue. I have currently broadband access connecting to the wan port of my ...
0
votes
0answers
134 views

Converting a cat5 to RJ45 for a wireless cisco router [closed]

I have a two level house. My modem and my first router are in the first floor. When we go to the second floor, the signal is very weak. I have an extra cisco wireless router that I can use as a bridge ...
1
vote
1answer
116 views

Configure WiFi router DHCP to assign IPs outside of subnet?

I have a slightly unusual issue with configuring a Wifi router on a shared office space network: We have a single ethernet connection to a building wide router A and we want to run a WiFi access ...
2
votes
1answer
529 views

Use ZyXEL WAP 3205 as LAN to WLAN bridge

I've got the following devices: ZyXEL WAP3205 WLAN Access Point [WAP] Comcast / Ubee device with 1 LAN port [COM] Laptop with LAN and WLAN [CLIENT] I want to connect WAP to COM via the LAN port ...
0
votes
1answer
452 views

Virtual Box Router - Windows Host, Linux Guest

I currently have Ubuntu Server running as the Guest OS in Virtual Box on a Windows 7 Host. The Ubuntu Server gets its IP from DHCP and is Bridged to the my Network Adapter. I've disabled Internet ...
0
votes
1answer
42 views

Stuck with ethernet

I have an old router that I was wondering if it would be possible to use it as a bridge as such to extend Ethernet For example Main router - Ethernet - Router 2 - Ethernet - device! Any help would ...
3
votes
1answer
270 views

Bridged DSL connection works for a bit, then fails bizarrely

I've got a BellSouth FastAccess DSL subscription that has run on an ISP-provided 2wire HomePortal 1700HW combination modem/router for a few years now with no significant issues. I recently acquired a ...
1
vote
0answers
50 views

How find IP adress of a lost Bridge

This is my network : (Yellow : Wifi and Green : Cable) Image Link : http://i.stack.imgur.com/AtewB.jpg (Sorry I dont have 10 reputation i'm new) My PC 3 can't obtain ip adress by DHCP because the ...
3
votes
3answers
6k views

Motorola NVG510 bridge mode

I have a Motorola NVG510 modem from AT&T, and I would like to disable all routing functions and use it as just a modem. I have a Time Capsule that's already connected and broadcasting its own ...
3
votes
2answers
701 views

Bridged Tomato network - problems with some devices on bridged wired segment

This is my network: Dotted lines indicate wireless connections, solid lines indicate Ethernet connections. I used two ASUS routers and Tomato to bridge my network. So I have have two wired ...
0
votes
1answer
746 views

How to login to my second router?

I have two routers, one ADSL router(A) which is connected to the phone line another wireless router(B) connected to this ADSL router. I connect my PC, laptop, mobiles to router B . like this: [ ...
1
vote
1answer
550 views

Bridging two connections in windows 7

I have recently bought an Samsung UE32ES5500 and I want to connect it to the internet. Not wanting to buy an expensive Samsung wireless adapter for the TV, I've decided to use an ethernet cable. ...
2
votes
2answers
394 views

Bridging multiple routers

I am currently living through router config hell. My main internet connection is in living room A. It is an PPPoE ethernet cable which goes into main WiFi router WR1 (IP 192.168.1.1). This device ...
0
votes
1answer
363 views

Server behind modem not reachable, “connection refused” [closed]

I have a Clear modem and a Netgear router that I set up last week. I have a server behind the router. I was forwarding all traffic from the Clear modem to the router, and then SSH-specific traffic ...
0
votes
2answers
499 views

Router in bridge mode

I'm setting up a new router to be an access point in bridge mode. Here is how my network is layed out: On side of property: - Internet - MikroTik router - Ubiquiti wireless radio Other side: - ...
0
votes
1answer
239 views

WRT54g router with DD-WRT firmware

I have a WRT54G router with DD-WRT firmware and have it set up as a wireless bridge. Currently it is connected to my main router and then I have a computer in the garage that connects to the WRT54G. ...
0
votes
1answer
332 views

Boost strength of router using multiple router's network through WAN

I have D-Link dir-600 router with dd-wrt firmware. I have two more APs belonging to my neighbors. can I use these APs to boost my routers strength over WAN. I can have physical access to neighbors ...
1
vote
1answer
923 views

Recommend Ethernet switch/bridge/router (VPN client, server is linux)

Can anyone recommend a small, highly reliable VPN-client-capable router/switch? Should have 4-8 Ethernet LAN ports, although could be combined with a small switch to reach this. The WAN port will be ...
0
votes
1answer
188 views

router relay or router bridge

i got a dlink wireless router. i have a client that has two station far from the router, so the connection is slow(10 kbps). for the netwok to be faster there is a need of a local lan switch. ...
2
votes
1answer
534 views

How to forward port when using 3 routers?

I've been struggling with my home network since I moved in but finally got to some results. Here's current set-up: INTERNET -> THOMSON 585V.7 (modem/Wi-Fi router) -> wireless bridge -> LINKSYS ...
4
votes
3answers
390 views

Using secondary router to create another network

To put things quickly into context, I've just moved into a shared house. The internet here is provided through a wireless router. I have some devices in my room that I would like to be networked, but ...
3
votes
1answer
1k views

Can a Netgear Wireless Cable Modem Gateway (CG814GCMR) be used as a wireless bridge?

Can a Netgear Wireless Cable Modem Gateway (CG814GCMR) be used as a wireless bridge?
1
vote
0answers
450 views

How to set up wireless access on a Cisco router

I've set up my 877W according to the configuration listed in this forum post: IPTV over Cisco 877 (It's the working configuration at the bottom of the post) Note that I have an 877W, so it also has ...
1
vote
1answer
5k views

How do I turn a router into a wireless bridge

I'm trying to get my HD satellite receiver connected to the internet - it has an Ethernet port on the back but my networking equipment is all upstairs. I had the idea of connecting a spare wireless ...
2
votes
2answers
2k views

cannot ssh to computer behind a dd-wrt bridge

In my home network , i have dd-wrt router in another room , which bridges wifi from main home router (linksys) to the computers wired behind dd-wrt router. Now I cannot ssh from my laptop ( ...
2
votes
1answer
2k views

How do I disable auto-negotiation on DD-WRT?

I have a WRT54GL router with DD-WRT firmware installed, and have the exact same situation as exposed in this thread. The problem is, I don't know how to disable the auto-negotiation on the router ...
1
vote
2answers
668 views

How do I bridge my Westell 9100 with another router?

I switched ISPs, and the new router/modem they gave me is a Westell 9100 VM60-10. I'm having all sorts of wireless problems with it, so I'd like to use it as a simple data bridge to my old router ...
3
votes
3answers
434 views

Wireless network relay?

Is there hardware (links would be great) that can connect to the wireless internet already in my house and provide hard links to other hardware? Basically the problem is that my basement is not wired ...
3
votes
1answer
4k views

Using a Wi-Fi router as bridge to increase the signal?

A friend of mine lives in an appartment building whose structure is such that the Wi-Fi signal is very weak. Even a USB key won't work. I was thinking of buying an entry-level Wi-Fi router and ...
30
votes
10answers
22k views

Can I make two wireless routers communicate using the wireless?

I want to make a setup like this: cable modem <-cable-> wireless router 1 <-wireless-> wireless router 2 in another room <-cables-> PCs in another room Basically, I want to extend my ...