0
votes
0answers
48 views

Access Transparent Router's Web Interface

A picture I made in paint is shown below which shows how my network is setup. The main router goes out to the internet. I connected a 2nd router to the main router in order to support older devices ...
1
vote
2answers
194 views

Linksys wrt54gl with Tomato running in client-mode not connecting to Cisco E4200

I have installed Tomato on my Linksys WRT54GL in an attempt to utilise it in client-mode to connect several wired-only devices to my other wireless router (the Cisco E4200) My Cisco E4200 is setup on ...
0
votes
0answers
16 views

vpn from another router onto main router

I have two routers at home. One "normal one" ASUS RT-AC66U with original firmware 192.168.10.1 and A tomato "flashed one" one 192.168.0.1 I needed the Tomato one for connecting my Voip via VPN ...
0
votes
0answers
49 views

tomato usb: Can't increase transfer rate above 54mbps in gui

Here is my setup: rt-n16 router v1.28.0502 MIPSR2Toastman-RT-N K26 USB VPN-NOCAT Set to N only 40ghz channel width I was fluctuating between 108mbps and 11mbps transfer rates and had an unreliable ...
0
votes
0answers
21 views

Why is there high packet loss when transferring across wireless network?

Normal internet browsing behavior does not trigger packet loss, but when I am doing a significant, sustained wireless to wireless transfers[0], packet loss increases to 30-50%. Wired devices are ...
0
votes
2answers
60 views

Can a consumer wireless router act as both a wireless client and access point?

I'm going to be moving in the future, and integrating my home network into that of my landlord. I wish to maintain an isolated network while using his internet connection, so I'm planning on cascading ...
0
votes
0answers
43 views

devices won't connect to bridge router

I've set up a bridge router with Tomato (by Shibby) firmware following this instruction here. Basically I set my bridge router to a different IP but the same SSID and pwd as the host router (from ...
0
votes
0answers
752 views

How to setup two-way routing with Tomato Wireless Client mode (different subnets)

Currently I have a Netgear R7000 as my main router, with internet coming from a Moto Surfboard SB6141 Cable Modem. I have a Linksys E3000 running Toastman TomatoUSB connected to the R7000 as a ...
1
vote
3answers
2k views

tomato firmware unstable when I am connected to Chromecast

I have an Asus RT-N12D1, and I installed the tomato firmware by shibby (tomato-K26-1.28.RT-N5x-MIPSR2-112-Max.trx and tomato-K26-1.28.RT-N5x-MIPSR2-114-Max.trx). However I found that the connection ...
0
votes
2answers
127 views

How to get tomato-like features on modern wifi hub?

I used to run tomato (shibby) on an asus wifi router, and it was great. I could: -- Run scripts on a schedule to modify iptables (e.g. block facebook at certain hours) -- Regulate bandwidth on a per ...
2
votes
0answers
188 views

“GSM only” mode in modem settings in tomato router

I use Shibby tomato firmware in ASUS-N66U. I use the "3G modem" option in it for WAN. it was working fine till now with my SIM's 3G data plan. I would like to use only 2G data from now, is there any ...
3
votes
1answer
234 views

Computer no longer connecting wirelessly to router after Tomato clean install

I just installed Tomato firmware (details below) on my wireless-N router and everything appears to be working fine on the router's end. I can connect to the Internet properly with a wired (Ethernet) ...
3
votes
3answers
475 views

Joining two routers together, but I have no access to the second router, although I know it's IP address and Gateway

I have temporarily moved into a rented apartment for 4 months, which has wireless. The trouble I am having is that the access points here are wifi only and no RJ45 and I need to use RJ45 to connect ...
0
votes
1answer
2k views

Tomato firmware - how to setup public wifi with login page

I have flashed tomato firmware on my Linksys E3200 router. I want to setup a public wifi (no password) like Target free wifi: when user goes to any webpage for the first time he will be redirected to ...
1
vote
0answers
362 views

Connect Tomato router over WiFi to public VPN WiFi and keep local WiFi & LAN behind NAT?

I want to use my Tomato based router as a WiFi gateway to the outside world, but also use the internal WLAN SSID. The reason is that I have a couple of devices that I do not want to connect to the ...
1
vote
1answer
219 views

Poor wifi connection - PC: 5 bars, Router: 1 bar

I'm having some problems with my Wifi setup. In a nutshell sometimes the performance is fine, sometimes it's terrible. When it's bad it seems to oscillate quickly between good transfer and very poor ...
2
votes
3answers
273 views

Speed test wifi connection?

I'm having problems with my internet connection, and I'm pretty sure it's my ISP, but I'd like to rule out the wifi connection between my PC and router. According to InSSIDER the radio connection is ...
0
votes
0answers
272 views

Why did my router randomly assign wireless devices to br0 interface?

So I have a WRT54GL router with Tomato firmware on. I have few wireless devices on my network. Most of the time they work fine, but occasionally, some devices that were previously on router's eth1 ...
1
vote
2answers
220 views

How do I debug a WLAN issue?

Our home network consists of a Fritz!Box 7390 as ADSL modem/gateway and an old Linksys WRT54G running Tomato as additional access point. The latter is dumbed down to be nothing but an access point, ...
0
votes
2answers
1k views

Can I/How to extend wifi range with WNR3500L(stock) and WRT54G(tomato)?

Some background: I live in an extremely wifi-busy area (after 5min of scanning inSSIDer shows ~40-50 APs). The way my apartment is laid out and wired is that wifi signal from/to my WRT54GL (with ...
1
vote
1answer
1k views

Extending a home wireless network using two routers running tomato

I have two Asus RT-N16 routers each flashed with Tomato (actually Tomato USB). UPSTAIRS: Router 'A' (located upstairs) is connected to the internet via the WAN port and connected via a LAN port to a ...
3
votes
7answers
7k views

Very slow internet with Linksys WRT54GL only in wireless mode (wired is OK)

I bought a new Cisco Linksys WRT54GL router to connect my laptop (running Windows 7) to the internet. I installed Tomato 1.28 firmware on the router. When I connect the laptop to the router via ...
0
votes
2answers
1k views

Extend wireless from tomato to dd-wrt over ethernet cable

I have a tomato router upstairs (192.168.1.1 connected to modem for internet) and a dd-wrt router (192.168.1.2 connected to .1) downstairs. I have cat-5 running between the two routers. I would like ...
0
votes
2answers
2k views

Accessing Tomato router in bridging mode?

I've flashed my Linksys WRT54GL router with the Tomato 1.28 firmware. This has worked fine, and I set its IP address to 192.168.1.2. I already had a wireless router, but the reason I bought this ...
2
votes
1answer
3k views

Why does pinging a local router return “Destination Host Unreachable”?

I have two tomato routers. One is bridged wirelessly with the other. I have a new server on the network. It's running Ubuntu Server 11.04. They are all connected like this: A - Linux PC B - New ...
5
votes
2answers
4k views

second router: access point vs. bridge mode

I have my main router running Tomato. My second router is configured as an access point using a different channel as the main router, but the same SSID/WPA2 info. All the firewall stuff, plus DHCP is ...
0
votes
1answer
184 views

Randomly unusable wireless connection. Oddest issue ever

I have two desktop computers a laptop and a smartphone. All of them connect perfectly to my router (WRT54GL with Tomato firmware), but randomly (once a week maybe) something odd happens: For over an ...
2
votes
1answer
278 views

Tomato Firmware & TC-ATM Patch

I have a router with the tomato speedmod patches applied (Viktek mod) and this is connected to an ADSL modem. How do I use the tc-atm patch? ...
0
votes
3answers
308 views

if i install an open source router firmware, will my connection be more reliable?

I've got a Linksys WRT-54G wireless router. The connection is flaky. Once or twice a week I come home from work and can't connect to the wireless so I have to reset the modem. It's annoying. If I ...
1
vote
2answers
284 views

Can I build two WLANs with Tomato?

My problem is this: I have a couple of devices connected to a WRT54GL with Tomato in the same network, both wireless and wired. I want to grant access to the internet to a notebook via wireless but i ...
4
votes
1answer
5k views

Tomato Firmware on Asus RT-N12

Has anyone gotten any luck with installing Tomato Firmware on an Asus RT-N12 and/or get WiFi 802.11n working? It seemed to flash correctly using the Asus Firmware and DD-WRT runs fine but it won't ...
1
vote
1answer
620 views

Laptop can't connect to wireless, requires reboot of router to get connection

I have a linksys router running the tomato firmware. Every day I have to power cycle the router to get my laptop to connect to it. All of the wired connections have no problem connecting. I have tried ...
2
votes
2answers
240 views

Setup a network using 2 modem and 2 accesspoint

Our dormitory has been equipped with 2 ADSL lines for about 60 students. Most of us just used internet for chatting, web-surfing and email, but there are few guys want to suck all the network ...
0
votes
1answer
4k views

OpenWRT/DD-WRT/Tomato-compatible wifi repeater?

I'd like to set up a wifi box to act as a repeater to pick up the somewhat weak signal of a friend's wifi router and make it available at my place. Ideally, I'd rather buy a device that supports the ...