Virtual private network; a network that connects remote sites or users via the Internet using virtual connections so that devices can communicate as if they were on a private network.

learn more… | top users | synonyms

0
votes
0answers
13 views

why cisco VPNC work on the second time each time and not on the first time

I use the vpnc ( cisco VPN that installed on linux red-hat 6.X ) and the vpnc.conf file look like this more /etc/vpnc.conf ## generated by pcf2vpnc IPSec ID Comvwde IPSec gateway 217.118.6.7 ...
0
votes
0answers
9 views

Use a VPN/… only for a specific port on windows?

I would like to know if there is a way to use another a software to redirect only some ports to another site? In my case I would like that the port 80(web) goes through a connection, and the other ...
0
votes
0answers
6 views

Forward a port to all users in Mikrotik RouterOS

In short: I want to know how to forward certain ports on Mikrotik's RouterOS. I looked up online and found several videos/tutorials but for whatever reason, I cannot do it. Please read below for more ...
1
vote
2answers
10 views

openvpn tls 1.2

Openvpn cant establish connection with any tls 1.2 cipher. TLS-DHE-RSA-WITH-AES-256-GCM-SHA384 TLS-DHE-RSA-WITH-AES-256-CBC-SHA256 TLS-DHE-RSA-WITH-AES-128-GCM-SHA256 ...
0
votes
0answers
17 views

Is it true that Microsoft OneDrive and OneNote cannot pass through VPN?

I had spent many days ping pong with the MS technical support for synchronization problems. While they have solved the basic synching, there is still one thing I am unhappy with. These Microsoft ...
0
votes
0answers
8 views

Configuration of Shew soft VPN client to connect to Cisco RV130 [on hold]

I setup a IPsec VPN on a Cisco RV130 and would like to know how to configure the Shrew Soft VPN client to it. Detail would be greatly appreciated. RV130 set to Phase 1 pre-shared key-sales Exchange ...
0
votes
1answer
20 views

Outlook can't connect to exchange, but via vpn it works

hello i have some trouble with my outlook.It cant connect to our exchange server, but when i activate vpn it works. All the other users doesn't have this problem. could you help me please?
1
vote
1answer
23 views

Making a juniper VPN work on linux

I've tried several tools, the original scripts (ncsvc and ncui) do not output any error message to know what wrong with connection, even with wireshark I could not know what was wrong. The best tool I ...
1
vote
0answers
12 views

Windows 8: Ping Result : General Failure after disconnect from vpn

In Windows 8 When i connecte to the vpn and then disconnect from it, i get general failure. PING: transmit failed. General failure. the routing table are: Network Destination Netmask ...
1
vote
0answers
93 views

OpenVPN Linux client - tls key negotiation failed to occur (FrootVPN)

I'm using the free FrootVPN service (works flawlessly on Windows). However on Linux I can't manage to get it to work. FrootVPN's support webpage is broken so I can't message their support. I know ...
1
vote
3answers
87 views

How to Power on a Computer remotely? [duplicate]

Our company has been asked to recently switch off our computers over the weekends to conserve power. Is it possible to remotely switch on a Computer if I'm able to establish a VPN to the Office ...
0
votes
0answers
10 views

Routing TCP traffic through cloud server

Is a scenario like this possible: Windows machine 1 (behind NAT) connects to a cloud server 3 (no NAT) Windows machine 2 (behind NAT) connects to the same cloud server 3 (no NAT) Is there a tool ...
2
votes
0answers
27 views

Routing traffic around VPN

I recently setup a OpenVPN client on my HTPC, however once I connected to the VPN server I was no longer able to remotely SSH or connect to the other servers I had running on the HTPC. I followed ...
0
votes
1answer
25 views

Mac OSX permissions

Please, before jumping to much appreciated answer, please read this, as my problem is not related to files and folders permissions (chmod and chown). I have a Mac, with 2 user, one is an admin, and ...
0
votes
0answers
33 views

How to Setup a Simple SOHO network [closed]

I'm rusty at being anything close to a IT type. Mostly do Automation. Need some help setting up the network in our office. Tried cruising for the answers but i'm getting confused. We have an LAN/WAN ...
0
votes
0answers
15 views

nmcli not working on bash script (but it does anywhere else)

I'm having this tricky problem trying to automatize a connection to a VPN. I have to ask for a password every time I want to connect, but I've already managed to request and parse it. The problem now ...
0
votes
0answers
26 views

Route between two OpenVPN tunnels

I need to set-up something like this: Clients - OpenVPN_tun0 - Int_Server - OpenVPN_tun1 - Ext_Servers - public_internet Both OpenVPN tunnels are up and running using 'dev tun', but I have ...
-1
votes
0answers
16 views

OpenVPN Bash Script [closed]

I want to ask whether such solution is even possible using OpenVPN not about details concerning script. Server side: CentOS 6.5 Client side: Windows 7 Bash or Python script having certain result ...
0
votes
0answers
28 views

How do I set up a VPN, such that I can connect to my Samba Share and printer?

I am looking for a way to set up my OpenVPN server so that all my internet trafffic redirects through it, and I can access my Samba Share through it. My samba share is located on my server machine, ...
0
votes
0answers
24 views

VPN without internet connection

I have a problem, which i'm trying to solve for couple days. I was create VPN server on my Win 7, everything seems to work good, except there is no internet connection on my browser. I still can use ...
2
votes
2answers
94 views

L2TP over IPSec VPN on Fedora 21

I need to connect a Linux Fedora 21 desktop to a L2TP over IPSec VPN. I was given a set of instructions for how to do so on a MAC as that is what they use but I have been unable to do so on Fedora. ...
0
votes
0answers
32 views

How to setup my VPN Server?

I had successfully setup vpn server on windows 8.1! Since, I am in a university, many sites are blocked, so in my vpn server I have connected through another vpn (OpenVPN, Psiphon etc.) But now I want ...
0
votes
0answers
28 views

Certificate errors while browsing on specific Wireless Network connection after installing my self-signed certificate for Access Anywhere [closed]

I was trying to setup VPN connection from a PC which is not in the domain. After trying out some stuff (among others I installed one self-signed certificate) I ended up in a state which I cannot ...
-5
votes
1answer
41 views

VPN, Proxy - Why we use them for? [closed]

Can anybody explain me what is a VPN/Proxy and why and where we use them for? Is there any connection between them? Thanks for the help!
0
votes
0answers
22 views

Clients get logged out after 12 minutes from VPN

I have installed and setup a PPTPD-VPN server on my Raspbian RPi to route my internet traffic through. It all works fine until (precisely) 12 minutes after login, then the client gets logged out. ...
0
votes
0answers
24 views

Websites and Netflix blocking connection from VPN

I use a VPN to browse internet sites. But when connected to the VPN, some sites are blocking or limiting access. One site declared that I had shut off the VPN before I could make a purchase from ...
0
votes
0answers
26 views

Cisco AnyConnect VPN “ping: sendmsg: Operation not permitted”

So, here it goes. I'm currently using the AnyConnect client to get connected to a VPN. However, since about three or four days ago, I keep getting this annoying error. When I connect I have access to ...
0
votes
0answers
14 views

How to create openvpn tunnel for multiple interfaces of a host? [closed]

I want to create OpenVPN tunnel between two Ubuntu 12.10 hosts which has two interfaces, say: Host1: eth0, eth1 Host2: eth0, eth1 A tunnel is wanted between: Host1 (eth0) <-> Host 2 (eth0) ...
0
votes
0answers
18 views

VBox NAT Network VPN

I wasn't quite sure whether to post this in a networking forum, or here, but I chose here since it is more software related rather than networking related. Basically, I want to be able to remotely VPN ...
1
vote
2answers
169 views

Yet another routing issue in OpenVPN - Cannot access local machines while on VPN

This is probably going to be quite a lengthy post because I want to make sure I don't forget anything. This is likely a very trivial issue but I can't figure out what's wrong with my setup. Scenario ...
0
votes
1answer
12 views

RDC - Screen Shifts to Show Local Task Bar

I have scoured the internet trying to find an answer and hope someone can help. I have a Windows 7 Pro laptop that I use to connect to a virtual machine at my place of work via a VPN. I recently ...
0
votes
1answer
17 views

SonicWall blocks from others computers in the local network

Sometimes I have to connect to my office using SonicWall VPN (version 4.9). When VPN is open, I can't access any of local computers/printers in the network. My local network is 192.168.2.0/24, and ...
0
votes
0answers
15 views

ASA Cisco VPN Connection drop when user switch is attached

Have established a VPN connection (albeit over satellite) between a Cisco ASA 5505 (running IOS 8.2(2) and the mother ship in the U.S. Firewall issues DHCP to internal interface users and the inside ...
1
vote
0answers
48 views

Unable to connect to Virtual Private Network

I am trying to figure out what is going on here as I am unable to connect to a VPN most of the time. I am using FrootVPN on the OpenVPN protocol. I used this guide to set it up. It is entirely ran ...
0
votes
1answer
24 views

Route traffic through different interfaces randomly

I'm connected to one server from multiple VPN [pptp] connections and each connection gives me a limited bandwidth. When I connect to multiple vpns windows sends all traffic through the last connected ...
0
votes
0answers
22 views

VPN is blocked only on windows?

Hi was trying to setup an vpn on my macbook because the network i am on blocks a lot of pages and it worked fine on the macbook i used the afreevpn.com vpn it worked no problems then i tried on my ...
0
votes
0answers
15 views

Routing only one Program through a VPN/Network card [duplicate]

A user uses a VPN for tons of reasons, Privacy, Evading blockades, or using apps/programs that are blocked on a network, a great example would be a school network! IRC's default port is blocked, ...
0
votes
1answer
34 views

Any solution using SMS to restart / reboot the router / server?

Given home network: VPN server behind NAT of a router office network: VPN client to access home resources Problem Either router/ VPN server is hung Unable to restart/ reboot them through ...
0
votes
0answers
21 views

Connect Xbox to VPN through DD-WRT Router

I'm trying to connect my Xbox One to a ping reduction service which is a PPTP VPN. I can connect to it in Windows 8.1 without any kind of problem. Here are the settings for security tab: Now, I ...
0
votes
1answer
31 views

Ubuntu guest in VirtualBox can ssh to VPN server under WinXP host, but not Win7 host after import

I just did a fresh install of the latest version of VBox (4.3.20) on my brand-spankin' new Windows 7 64-bit machine, then imported the vdi file describing my Ubuntu guest installation (14.04 32-bit) ...
0
votes
0answers
28 views

Copy a Windows VPN client configuration to a Linux client so it also connects to a Windows VPN Server

I have two virtual machines at hand, one Windows 8.1 and the other Debian 7.7 linux. The first one (Win8.1) was already configured to connect to a Windows PPTP VPN, I now need to do the same on the ...
0
votes
0answers
26 views

How to easly block user from using surfeasy VPN

Does any one know if its possible to block user from using using surfeasy VPN to download pirate movies from the internet?
0
votes
0answers
27 views

Set up OpenVPN network to allow access to machines on remote LAN even if they have the same address as machines on local network

I have a Linux machine set up as an OpenVPN server, with the main function of having a secure way to connect to my home machines via SSH from outside, primarily using Android devices. My home ...
1
vote
0answers
20 views

Override DNS order when conencted to a VPN?

I'm having some issues with DNS when I connect to my VPN from my Mac. When not connected, scutil --dns (the DNS lookup table) returns: resolver #1 nameserver[0] : 10.0.1.1 flags : Request A ...
0
votes
1answer
38 views

How does Windows 7 store a mapped network drive? I have one that cannot be deleted, and connects in spite of a required VPN being inactive

When I type \\192.168.1.2\ into Windows Explorer on my desktop, it is connecting to another one of my servers halfway across the state of Pennsylvania and I have no idea how. I have absolutely no ...
1
vote
1answer
30 views

How to make OpenVPN client work on UDP only and a non-default port?

I wanted to configure OpenVPN to run on a non-standard UDP port only, to avoid opening several ports on my router for port forwarding. However, it looks like the OpenVPN client can only connect if I ...
0
votes
1answer
37 views

Routing internet traffic via site-to-site VPN remote router instead of local one

We have a setup like the following: VLAN 90 ---- FORTIGATE ----- INTERNET ----- CISCO ROUTER ----- VLAN 31 IPSEC VPN TUNNEL I can ping the VLAN 31 router and subnet ...
0
votes
0answers
16 views

Max OSX can not connect to PPTP server

I followed the guide lines in Easiest way to setup Ubuntu as a VPN server on my newly created Linode VPS, but My Mac won't connect to that host. I can ssh to that host, though.
0
votes
0answers
30 views

Access router management from VPN

I'm using a tp-link TL-ER6120 router in order to use a VPN. The LAN is using the IP range 192.168.100.1 - 255, and I have a TP-Link Archer C7 Wireless router (as AP, with DHCP disabled and connected ...
0
votes
0answers
31 views

no received packet on osx yosemite using pptp connection

i am very new at this networking stuff. what i want to archived is - accessing and browsing internet using my vps ip on other country. ( so i can bypass my country blocked website ) - sharing my vps ...