0
votes
0answers
11 views

Draytek 2820 Router slow upload speed?

We have a 20m/20Mbit line. We used to have a cheap sonicwall firewall running the connection at the full speed, but due to some other issues with it, we changed to this draytek vigor router. The ...
2
votes
2answers
57 views

Cannot reach the computer in WAN

I wanted to split the internet connection in my room. And my brother also wanted a better wifi accessability. So we bought a router (NETGEAR JWNR2010v5). All we wanted works great, good wifi. I have ...
0
votes
0answers
18 views

DLink 614+ Connect two LANs

I have a DI-Link 614 router. As WAN connection I have a LAN which has access to internet and I do not manage it. I have 2 computers (PC1, PC2) and 2 devices connected to the router. I have ...
-1
votes
1answer
119 views

Time Capsule Wireless spot give enormous latency

Noticed, that after a day or a two of use of home network I getting enormous ping time to ADSL modem. Usually it's about 2 ms. But when problem appears - it's 500++ ms. After Time Capsule rebooting ...
1
vote
1answer
112 views

Connect my router to the internet via another router?

What I want to do: Connect to the internet through my wifi router, via some other router that the room I rent provides. What I have: 1 ethernet cable that comes into my apartment. If I plug the ...
1
vote
0answers
75 views

Is it possible to bind an application to a specific WAN port using a DI-LB604 dual wan Router

What I'm trying to do is bind applications to specific WAN ports to maximize internet usage and prevent applications from getting all the bandwidth as well as categorizing which ISP they should be ...
0
votes
0answers
58 views

how to connect to WAN through wireless network bridge

I'm currently using TL-WR740N to connect to internet using the setting in the following picture by using a LAN wire provided by my ISP in my router's WAN Port. my question is how can I connect to to ...
2
votes
0answers
432 views

Assign LAN port as WAN on Technicolor TG582n router

I have recently switched my home Internet connection from copper to fibre. With a copper installation I had a Technicolor TG582n router (Technicolor 582n - ADSL2+ / ADSL2 / ADSL - see top of linked ...
1
vote
1answer
373 views

Need iptables commands to permit all WAN originating traffic to enter the LAN side of a router

I have three routers. Router0's WAN interface connects to the ISP, and the WAN interface of Router1 and Router2 connect to Router0's LAN interfaces (i.e. hard wired). So this is what it looks like, ...
2
votes
1answer
122 views

Can router connect back to itself over Internet and why?

As it it sates in title. Every router I had couldn't connect back to itself over Internet, for example: I open forward port 22 for ssh on my PC. I try to connect to that ssh with other PC in same ...
0
votes
1answer
210 views

Magento Localhost Installation - LAN Works - WAN Issues?

I’m new to home servers and Magento. Running Ubuntu Server 13.04 with LAMP and Magento Commerce 1.7.0.2 on a dedicated home server. I've already configured my server's static IP, router's firewall and ...
1
vote
1answer
98 views

Combine my network with my neighbors network

My network and my neighbors network are connected (we share my server). We both have our own WAN-connection to the internet. Right now we use the following setup: Neighbor: Internet --> router ...
0
votes
0answers
221 views

Tenda router unable to connect to some sites

I have Tenda N ADSL2+ router. I configured it correctly. Now its connecting to internet but unable to connect to many sites like yahoo, the pirate bay etc. When I searched Google, I found that many ...
2
votes
2answers
332 views

Netgear WNDR4500 listening on port 80

I have a Netgear WNDR4500 that I use for my home router. I also have my own domain with a subdomain point to my IP. I happened to browse to it today and noticed the management console was listening ...
1
vote
1answer
278 views

Dual WAN Router with Load Balancing AND Fail-over

This might be a silly question... We are looking for a Dual WAN Router for fail-over reasons, but since we pay for both connections anyway, we might as well take advantage of them. What confuses me, ...
2
votes
1answer
2k views

WAN port Unplugged

I have iBall 150M Extreme Wireless N Router. I am trying to connect my internet through this router. I configured it correctly (using quick configuration) as per my knowledge using static IP Address. ...
3
votes
3answers
2k views

Is there a dual-WAN router that can route based on protocol?

I've got two internet connections at home: DSL and satellite. The DSL connection has bad bandwidth (1.5 Mbps) but very low latency; the satellite connection is the opposite (good bandwidth, terrible ...
0
votes
2answers
5k views

How can I change my current public static IP address? [closed]

I tried the similar posts' solutions but I couldn't get it to work. I have tried: Releasing and renewing the WAN. Unplug the router, wait for a night and plug it in again. I have looked on the ...
1
vote
1answer
1k views

Cannot access home server from home network, but can access from internet

I have an Apache server at home and a router configured to assign a static IP address to that server. I also have the ports forwarded correctly for Apache and SSH. I can access the server with my ...
6
votes
3answers
9k views

Finding router's WAN/External MAC address

I want to find my router's WAN MAC address. On the WEB UI, WAN MAC is hidden. SSH / Telnet is not available (password protected) on router. There is no labels/engravings on physical unit which ...
0
votes
2answers
821 views

Unable to connect to local computers in WAN of DD-WRT router.P2P networking not enables

I have Dlink DIR600 router and I upgraded to DD-WRT recently. We 7 students share an internet connection via wireless router. all 7 laptops are assigned an IP by router Problem is we are not able ...
1
vote
1answer
856 views

Router resolves LAN DNS names to WAN IPs

I have a router on a LAN with 4 computers. One computer is a server with a static IP; the others are dynamic IP. All 4 DNS names resolve to an IP that is outside my LAN (i.e. a 208.* address instad of ...
0
votes
1answer
1k views

Map a SMB-drive outside of the LAN

Is it possible to map a network drive in Windows 7 connecting to a NAS on a another local network (behind a firewall)? Here's my setup (so far): - Linksys wireless router connected to the internet - ...
1
vote
1answer
1k views

How to connect 2 routers (Asmax and D-link) RJ11 vs RJ45 issue

I just bought a new router, D-link DSL 2641B and want to connect it to another one, provided by my ISP, Asmax AR 804MP. Previously, I had Linksys WRT350N, and there was no problem, while I had ...
0
votes
3answers
4k views

Convert to WAN port

I have a ADSL2+ Modem/Router. Is it possible to set one out of four of the LAN ports as a WAN port? If yes, how? The brand/model is: Prolink H9200P. I already contacted Prolink about this and the ...