0
votes
0answers
6 views

HP 6520 stops connecting to EnGenius ens202ext

We have multiple EnGenius ens202ext AP around campus and I connect our HP6520 printer no problem, Also connect iPads to AirPrint to the printer. Everything worked fine for about an hour. Then the next ...
0
votes
0answers
12 views

Engenius ENS202EXT multiple AP on campus Channel conflict?

I have 10 of these AP around campus, all about 75-200 ft apart from one to the other. I have had them set up on auto channel since I have had them but two of them have a couple issues. One of them ...
-1
votes
0answers
9 views

Wireless A/C Network throughput vs mbps [closed]

Why is wireless A/C better then wireless N and will a 5gZ witless network actually be faster then 2.4 Ghz once everyone has a 5ghz gateway? Does throughput overcome bandwidth...width that should ...
0
votes
0answers
10 views

implementing a mitm attack (deuath) on network clients to LIMIT bytes per second

good day all In short, I need to limit the network usage of clients on my home network, since there has been some high activity and I am not able to stream a p240 video on youtube/twitch, I wouldn't ...
0
votes
0answers
17 views

Can a PCIe wireless network adapter be used as a full access point, and if so how

I have a TL-WDN4800 PCEe (450Mbps) on my desktop (originally to connect to WiFi when I was living in a different house), and I would like to make this into a wireless access point (I have no need for ...
0
votes
0answers
10 views

Wifi not able to choose between the available APs

I am using my laptop to connect to a wifi network at office. The office setup is such that there are many access points set up at multiple locations in the floor. The place where I sit is in such a ...
1
vote
1answer
70 views

How many Access Points will be needed to accommodate 350 users? [duplicate]

In a few weeks, I'll be helping with the technical aspects of a conference. One of the things that participants will need is access to to documents, via a laptop as a document server (set up with MAMP ...
0
votes
3answers
35 views

Are there Ethernet Over Power WiFi Access Point devices? [closed]

I am looking for the following device, as part of my network configuration: An Ethernet over Power device, that once plugged into the electrical socket (which already carries data) will function as ...
0
votes
0answers
21 views

Indoor navigation Access Points or WDS (WiFi Repeater)

I want to attempt a small in-door WiFi navigation project I have no problems regarding programming but I'm lost on the Networking part. Basically what I need is WiFi routers under same network name ...
0
votes
1answer
52 views

Optimal Wi-Fi channels in 2.4 GHz

Everybody is talking about 1, 6 and 11 being the best channels. But nobody is differentiating between 802.11b, g or n. I found this illustration, which shows the channels that don't overlap for the ...
0
votes
0answers
24 views

tomato usb: Can't increase transfer rate above 54mbps in gui

Here is my setup: rt-n16 router v1.28.0502 MIPSR2Toastman-RT-N K26 USB VPN-NOCAT Set to N only 40ghz channel width I was fluctuating between 108mbps and 11mbps transfer rates and had an unreliable ...
1
vote
1answer
47 views

Wifi Snooping over phone

I connect to the wifi acccess-point at work, but recently I suspect that data on my phone is being snooped-out from my phone connected to my office's Wifi network. [Phone Model: Sony Ericsson Xperia ...
0
votes
0answers
20 views

How to create a dhcpd.conf file

I have followed the tutorial on this page to create an access point on an Arch Linux install. It seems that went mostly ok apart from an error from DHCPD server: Internet Systems Consortium DHCP ...
0
votes
0answers
55 views

How does my ISP knows that I am sharing my internet connection? and how to bypass it?

I am in a student residence hall.There is one ethernet socket in the room. I can connect my laptop to the cable, but how can I get internet in my iPad? It will be good to have internet on both of ...
0
votes
0answers
16 views

Configuring two nearby WLANs: should I use the same ssid? [duplicate]

I'm configuring a home network for basic internet use (ie don't really need connectivity between workstations on the network). My brick walls mean a single wireless router doesn't provide good ...
0
votes
1answer
232 views

TL-WN725N Access-Point on ArchLinux + Hostapd

I bought a TL-WN725N v2 wifi usb dongle for my Raspberry. Amazon read it would work out of the box but it didn't. So I followed several tutorials to have the driver working. Now the problem is to ...
-1
votes
2answers
38 views

Wireless WLAN Transmitter for Desktop Computer? [closed]

I would like to know whether I can buy a Wireless WLAN Transmitter for my desktop computer in order to not use a internet cable to connect to the internet but rather via my router's wireless WLAN ...
0
votes
2answers
55 views

What hardware is necessary to provide WiFi for an outdoor business?

My in-laws own a campground and are looking to provide free WiFi for their guests. They are a small operation and are on a budget, so I have decided to help look into this. Here are some basic ...
0
votes
1answer
49 views

Wireless clients on an access point cannot see each other

I have my main router in the basement and a dlink dap-1360 access point on the second floor connected by ethernet. I've assigned a static ip to the access point. It shares the same SSID as my router, ...
1
vote
3answers
262 views

wifi usb adapter can connect to one, but can't connect to another wifi network

On the desktop computer I'm connecting to a wifi using usb wifi adapter. I have two available networks, my home network and the one from the neighbor. When I want to connect to my wifi network, it ...
0
votes
2answers
67 views

Can a device connect to a new network with a previously used SSID and password?

Imagine I own two buildings, building A and B are 10 miles apart. I connect my device to the WiFi in building A (enter password etc) before heading to building B. Is there any configuration which ...
3
votes
0answers
183 views

How to setup Access Point (WiFi hotspot) on Debian

I'm trying to setup an AP got stuck. I'm using an Odroid U3 and the WiFi adapter is the Module 3 from Hardkernel. I'm also using a Debian Jessie. Not, I've got it to almost work: the Odroid has ...
0
votes
1answer
35 views

Configuring a repeater for a non-native vlan

I my office I have 3 Cisco Aironet 1130AG series access points. I want to setup a new access point as a repeater. So far I have configured it a repeater using Cisco's website. Also, I am configuring ...
-1
votes
1answer
55 views

How to find which WDS access point I'm connected to?

I'm reposting this question I asked on the Network Engineering SE, bacause I have been redirected to Super User. I have successfully set up two Linksys routers running DD-WRTv24 to do WDS. They have ...
0
votes
0answers
29 views

How to know which of the access points is the root access point

I my office I have 3 Cisco Aironet 1130AG series access points. I want to setup a new access point as a repeater. So far I have configured it a repeater using Cisco's website. Also, I am configuring ...
0
votes
1answer
42 views

How to find out if a linux machine was connected to a certain wireless access point ?(wireless connection history)

I am trying to find out a piece of log that states that a machine was connected to a certain wireless access point sometime in the past. Where exactly does linux store this information.(some file in ...
0
votes
0answers
91 views

Dual WiFi Access Point Setup with Android

I have 2 identical (model, firmware, etc) 802.11n WiFi routers acting as WiFi Access Points by having both configured with the same SSID, password, security type, etc but different wireless channels ...
0
votes
0answers
32 views

How do I share internet for Hyper-V clients and Wi-Fi hosted network?

I am able to share my internet connection with either Hyper-V clients (using virtual internal switch) or the hosted Wi-Fi network clients but not at the same time. Is there a way to share an internet ...
1
vote
0answers
31 views

access point wifi + linux

I have been succesful creating a wifi access point in linux. I have used hostapd and a dhcp server. I have also used a static address using the command: ifconfig wlan0 10.10.0.1. I would like to use ...
0
votes
1answer
80 views

How to extend wireless network via LAN and not wireless?

See diagram I have an Edimax RW-7228apn wireless access point. It has LAN IP of 10.0.0.1. I have recently bought a TP-Link TL-WA830RE Wireless Range Extender to give me extra wireless coverage. I ...
1
vote
2answers
261 views

How to install wireless access point EDUP EP-2906?

I 'm trying to install wireless access point device EP-2906, on my Desktop PC running Windows 7. Here is the installation guide. Page 7 says how I can set up it's IP address, but I can't find ...
1
vote
1answer
43 views

Requirements for bridging LAN over WLAN

I need to connect a rear to a front house, cable is not possible. The front house has a Cisco WRVS4400n router, providing 2 SSIDs - SSID1 in VLAN1 and SSID2 in VLAN99. The rear house now needs VLAN1 ...
0
votes
0answers
79 views

What Wifi USB adaptors could work in __ap and station mode at once

I followed these instructions and still can't get AP working on the same interface. I have these devices: Ralink corp. RT3060 Wireless 802.11n 1T/1R is giving me an error: RTNETLINK answers: No ...
0
votes
1answer
31 views

Channel overlapping vs overcrowded

In my area i can detect 41 different AP, almost every channels are in use and there is no way to avoid channel overlapping. i try to choose the standard channels (1,6,11) and keep having slow internet ...
1
vote
1answer
30 views

Routing access point internet through PC on same network

I have just bought a Cisco wireless access point (Cisco Wireless-N Access Point WAP4410N). It is connected to the same network as my computer. My devices can connect to the access point and get ...
1
vote
2answers
50 views

FVG318 used as a Wireless Access Point

My apologies in advance: I am a software developer with just enough networking knowledge to get into trouble :) So I had a cable modem/router setup through my ISP right in my office. They sold me on ...
1
vote
1answer
47 views

What controls the node connections when multiple access points with the same SSID are present?

What would govern the nodes connected to a wireless network when I have multiple access points that use the same SSID for roaming? I believe there is a command that shows the associations in Cisco IOS ...
0
votes
1answer
200 views

DD-WRT: How To Do Multiple APs on Wired Network?

I've been following the page on the DD-WRT web page for linking routers as WAP's (wireless access points, both connected through a wired connection) [1], and I'm finding the following issues: I ...
2
votes
0answers
187 views

Internet Connection Sharing (ICS) hangs

I am sharing my Wifi internet by creating a virtual network through the following commands netsh wlan set hostednetwork mode=allow ssid=MyWifi key=XXXXXXX netsh wlan start hostednetwork It works ...
2
votes
1answer
76 views

Why should the SSID be the same when installing multiple access points?

I understand that the best practice for installation of multiple wireless access points (in a home environment for example) is to give them the same SSID, but why is this the case? Why not give them ...
0
votes
0answers
95 views

can not to connect to my printer on the same access point

I have a router and an access point setup. my access point ( engenius ecb 300) which is located at the second floor is utp-wired to my router which is located at the first floor. My printer is in ...
0
votes
0answers
83 views

Wifi extenders: sharing private subnet

Apologies if this is a duplicate, it probably vaguely overlaps other questions. I want to create shared folders among home computers and laptops etc. running windows and linux (workgroups / samba). I ...
1
vote
1answer
387 views

Adopting 802.11n, how to set it up for simultaneous dual band

I'm looking into upgrading my current Tomato ap to a 802.11n compliant access point initially using DD-WRT x86 until pfsense 2.2 alpha is out because pfsense 2.1 doesn't have 802.11n support. I'm ...
1
vote
3answers
90 views

What technology to use for home network

I live in panel-house (cube with concrete walls, reinforced with steel) which is part of bigger block. Recently I have successfully setup wifi network through the flat, but at the recieving end I have ...
0
votes
1answer
42 views

Access point with whitelisted site

I need to set up access points for our customers. Each customer will get its own access point. On each access point the visitors can connect to the wifi since its open and not password protected. ...
1
vote
1answer
62 views

Bridged routers - can route one way but not the other

I have a SKY router (D-Link DSL-2640S) which is my main router and a TP-Link TL-MR34220 which is connected wirelessly to the SKY one. I have OpenWRT on the TP-Link. I have a Raspberry Pi and a WD ...
0
votes
1answer
55 views

Setting up a LAN with multiple APs

I need to setup a network, and I guess I need some advice. Basically, the physical setup is like this: Our house has two floors. Telephone connection is at 2nd floor. No wired connection between ...
1
vote
1answer
98 views

Does a limited bandwidth homespot affect the bandwidth of my personal network?

I have 4 networks at home: a 5 GHz network and a 2.4 Ghz network from my own router, a 2.4 Ghz network from the router/modem of my ISP and another 2.4 Ghz homespot from my ISP, intended for other ...
3
votes
1answer
1k views

WiFi UDP unicast vs. multicast speed

From what I have gathered UDP multicast / broadcast over WiFi will not yield the speed as one would have thought. What about UDP unicast over WiFi? Can anyone confirm that the latter will have a ...
3
votes
2answers
263 views

Why do I lose my 3G connection when I connect to my new wireless access point?

I've just bought a TP-LINK Wireless Range Extender (Model TL-WA83ORE) to use, for now, as just a pure access point, to link up my notebook, printer, and phone, without troublesome and messy USB ...