0
votes
0answers
17 views

Bridge a 3g connection with ethernet

Line-up: 1. An 3G usb dongle stuck in a laptop with ethernet port and wi-fi disabled. 2. An wi-fi router serving as dhcp server for another 3 wi-fi routers configured as access points. All those 3 ...
0
votes
0answers
21 views

Create WiFi Network Using LTE Hotspot + Airport Express

I have an LTE hotspot (Samsung, no ethernet) from T-Mobile. I'd like to use this as the "link" for my office LAN. What is the best way to extend this wireless (LTE) link to the LAN created by an ...
0
votes
1answer
27 views

Verizon Fios Wireless router and ethernet outlets in various rooms of the house

I have Verizon FIOS and with that a Verizon wireless router (in a closet upstairs) in which the 4 ethernets ports are connected to a panel where there are 4 ethernet ports. Each port from that panel ...
0
votes
0answers
16 views

Default gateway is not available message, when using a router both in wired and in wireless setting

I recently rented a room which provides Internet connection via Ethernet cable only, but I really need a WiFi, so I bought a router. I set up the device but the thing is that the connection goes down ...
1
vote
1answer
32 views

Captioning Phone- Ethernet Splitter or Switch

I have a captioning phone that I use for work (hard of hearing) and the phone requires an internet connection. Seeing that the wifi is building wide it is recommended that we use an ethernet ...
0
votes
0answers
29 views

Connecting a wired ethernet device to a Maplin N300 wifi range extender?

I've purchased a Maplin N300 Wifi plug-in range extender which I've configured into my home wifi and it works great as a wifi extender, testing it by connecting my phone to the new AP. It's probably ...
0
votes
0answers
41 views

Intermittent connection drops on Win 8.1

This is a laptop system. I currently have an issue where my network connection will drop intermittently for anywhere between 5-15 seconds at a time. This is enough to disconnect me from anything I'm ...
0
votes
0answers
31 views

Sharing of Adsl internet through a ethernet modem to a wireless routher

I've been struggling a few months now , our uncapped internet runs to a modem into a hub , via ethernet we share the internet with our flat 20metres away. We now use a wireless routher as a hub in the ...
0
votes
3answers
43 views

What do I need to make my Ethernet-connectible printer accessible by wireless?

I use a 802.11 wireless network. I have a printer which has an RJ-45 Ethernet port, which is no physically close to to anything like a Wireless-to-Ethernet router. I would like to add as little ...
2
votes
1answer
78 views

What's wrong with my home networking setup?

I have the following home network setup: Ground Floor Typical Wireless router which is connected to WAN/Internet and its LAN IP is 10.0.0.1. DHCP is ON with the address pool set to 10.0.0.100 to ...
0
votes
1answer
53 views

Is it possible for a desktop computer to use a laptop's WiFi? [duplicate]

Given a curious setup, my desktop computer is now far from an accessible connection to the internet as it lacks WiFi, yet I do have a spare laptop lying around with WiFi capabilities. Is it possible ...
0
votes
1answer
27 views

conecting my ps to my tv using ethernet

i am trying to connect my tv to the internet, my pc receives a wifi signal via my neighbours router and i am wanting to send that signal via my pc's ethernet port to my tv using an ethernet cable. my ...
0
votes
1answer
42 views

No connections are available

Desktop machine operating on Microsoft Windows 7 Ultimate 64-bit Service Pack 1. Ethernet cable is plugged into the computer on one end, and into the WAN port of the wireless router on the other. ...
0
votes
0answers
83 views

Use wifi for internet but access a printer over ethernet

In my office I have a Wifi connection and a LAN connection the printers are connected via LAN. LAN and Wifi both have internet but the LAN internet is slower. I want to use internet through Wifi but ...
0
votes
0answers
37 views

Routing data over WiFi and Ethernet in Windows 8

I have a wireless connection that I use for internet and an Ethernet connection which connects to another router that is set up as a client repeater bridge (dd-wrt). I want to be able to connect to ...
0
votes
0answers
38 views

Skydog is slowing my internet speed

I have two systems running my internet at home: Skydog and BOB (iinet). When I use Skydog (either by Ethernet or wifi) my load speed slows dramatically. However my Dad’s computer runs perfectly both ...
0
votes
1answer
40 views

Share internet connection to ethernet and hosted network

I have used my iPhone as the source of internet using USB connected to my laptop (Local Area Connection). How do I share the connection to: a computer connected via Ethernet a hosted network ...
0
votes
2answers
34 views

multiple network interfaces, browser issue

I have two network interfaces on my laptop: wireless, and wired. The wireless network is connected to the internet (automatic, dynamic ip assignment). The ethernet card is connected to an embedded ...
2
votes
1answer
75 views

How do I switch from ethernet to WIFI (and vice versa) without losing connection?

I there a way to switch between ethernet and WIFI connections without losing connection? I am downloading a huge file via Firefox without an option to resume.
0
votes
1answer
61 views

Wireless or wired LAN: Which consumes less power?

I have a printer that has Ethernet LAN and Wi-Fi WLAN. The printer is seldom used, so I'm interested in minimizing idle power consumption. My Wi-Fi AP is on anyway, so that's not interesting. My ...
0
votes
1answer
51 views

Authenticating to Open Wifi with Linux CLI dies with (reason=3)

I am running Ubuntu 12.04 LTS and tried the following... I have a Netgear WNA-1100 USB stick plugged in and used /etc/init.d/network-manager stop to disable NetworkManager, since it interferes with ...
0
votes
1answer
66 views

Can not access local network through devices connected through wireless

I have a D-Link DSL-2750U ADSL router (Firmware version: IN_1.08). I have 4 devices connected with following IPs: Router (10.0.0.1) WireConnected1 (10.0.0.4) WireConnected2 (10.0.0.5) ...
1
vote
3answers
402 views

LAN transfer speeds cat6 vs wireless

The current setup is one file server (windows) serving 3 other windows 7 computers (identical spec) via cifs/windows file sharing. The server is connected via ethernet cable to router(netgear ...
1
vote
2answers
37 views

wireless connection get listed as eth1 + UNIX + MacoX

I'm not sure what is the best word to put forward for this since I'm connected to my wireless router and by that definition I was assuming the ifconfig to list my ip in wlan0 section but it display ...
0
votes
1answer
801 views

Connect to internet with wifi, while wired to a different LAN through ethernet

So I have a small router I'm connected to through an ethernet cable, and I'm having multiple devices connecting to that router through wifi, so they can view my computer screen. Screen sharing on ...
1
vote
2answers
55 views

Choosing from multiple network connections

I have two different ISPs in my home and also two different routers. I'm using one for Wireless, and one for ethernet. On my PC here, it has both wireless and ethernet connections setup at the same ...
0
votes
2answers
205 views

Ethernet (en0) loses IP address when WiFi (en1) starts/stops on OSX

We're using the Ethernet connection as a point-to-point connection to a lighting console and then the WiFi to connect to the main network. The issue is whenever we turn the WiFi on/off the Ethernet ...
0
votes
1answer
71 views

Is there any device that receives WiFi signal and translate to an ethernet?

I was looking for a device that receives my house WiFI and gives me an ethernet, if possible a very high speed WiFi, I would like to put cables everywhere but I can't actually, so this would be my ...
0
votes
2answers
34 views

Dual wifi router setup

Can I use a gigabit ethernet switch plugged into my cable modem and then plug two different wifi routers into the switch. I want to use my new high speed router to always go through my VPN and my old ...
0
votes
0answers
26 views

Properly sharing windows 8 ethernet over wifi

I'm trying to share my ethernet network over a wifi card on my windows 8 pc. I have been able to do it following some guides online but when connected to the wifi hotspot, it doesn't have an ip ...
1
vote
2answers
88 views

Unable to access static IP of wired device connected to wireless network

I have a proprietary device with a static IP. I have connected this device to my wireless router through an ethernet cable. When I connect my laptop to the router via ethernet, I am able to access ...
0
votes
2answers
49 views

Download and upload from different router using eth0 and wlan0 connection

I have 2 modems, one with 5 mbps upload and another one with 8 mbps download. Is it possible to connect one from wlan0 and another from eth0 interface and use one of interfaces for download and ...
0
votes
0answers
24 views

How can I configure 2 UNIX hosts to share a single wireless router connection?

How can I share my MacBook Pro's wireless 802.11ac connection with a fairly old dual-G5 server? So, I'm thinking that rather than run a CAT6 cable down the middle of my kitchen, I simply connect my ...
1
vote
1answer
141 views

Ethernet for Internet, WiFi for VSwitch

I would like to: Connect to the internet using the laptop ethernet port. Share the Wifi on my laptop to a Hyper-V VSwitch and connect "physical" clients to the Hyper-V domain. (Tablets, laptops, et ...
22
votes
6answers
7k views

Do cabled connections and Wi-Fi “use” the same bandwidth?

My brother likes to play games online on his Xbox. However, because he is far away from the router, he uses our Wi-Fi instead of an Ethernet cable. I, being closer to the router, use an Ethernet cable ...
0
votes
0answers
44 views

Need help for setting up network cameras

I am newbie to here and I do need help from any of you. I work in Japan and I have a shop in Thailand. I would like to set up network camera at my shop in Thailand and I want to look my shop from ...
0
votes
0answers
21 views

Using ADSL Router With LAN Internet As Input [duplicate]

Can I use ADSL modem with Ethernet LAN? The purpose was to broadcast LAN wire internet over WIFI. By mistake,I bought ADSL router, it accepts telephone jack input only as input internet Is there ...
0
votes
2answers
1k views

Does the length of Cat5e cable affect the network speed?

Ok for starters we have Time Warner which happens to be the worst provider ever. We have two PCs(windows 7) and two Laptops(windows 8). We are paying for 100mbps our laptops on wifi average around ...
0
votes
0answers
40 views

Using 2 internet connections - (1 wifi - 1 ethernet) - on the same machine at the same time OSX

Is it possible to use 2 internet connections - 1 WiFi 1 Ethernet at the same time on a mac mini (OSX) ? Ive got 2 lines coming into the premasis and would like to use one for backups and one for ...
2
votes
1answer
111 views

Can't use Wifi when Ethernet is Active

I'm not able to use Ethernet and Wifi Simultaneously on Windows 7. I've read that it is supposed to be default in Win7, but when I connect the Ethernet, I can't connect to WiFi. A pop-up comes up ...
3
votes
3answers
116 views

Why is my wireless internet connection abysmal when my wired connection is great?

I know speed is likely to be slower over Wi-Fi than ethernet. This is about the consistency or persistence of the connection itself. When I'm plugged into gigabit ethernet, I get a great connection, ...
0
votes
0answers
54 views

How to I access router admin page if I'm bridging my laptop's wifi connection to it via ethernet?

I'm using my laptop to get internet via wifi from a public network. I then connect my laptop's ethernet port to the uplink port of the router and set up the bridged connection in windows' ncpa.cpl ...
1
vote
1answer
101 views

Connecting two wireless routers with ethernet - will the secondary router transmit wirelessly?

I have two wireless routers. The primary router is a Thomson TG784 is wireless modem router. The second wireless router is a TP-Link TD W8950ND. If I connect the primary router to the secondary ...
0
votes
0answers
63 views

Creating a router “spreader”

So at my room at home, I have 2 extra computers, with like 1gb ram on each. I have the router on the other side of the wall, where a ethernat cable cannot reach it. It has to go through a wall first. ...
0
votes
1answer
151 views

Home LAN - heterogeneous network with two SOHO routers as WLAN Access Points - Failing

I have the first world problem that my home requires more than one WiFi access point (AP) to have coverage throughout the house. PROBLEM My wired router, directly connected and adjacent to my cable ...
0
votes
2answers
449 views

Enable Internet (Wi-Fi) and Intranet (Ethernet) to work at the same time

EDIT: OS is Windows 7. I have seen a couple of threads about this, but I am so limited in my networking knowledge that I have been unable to get those solutions to work for me. I am trying to ...
1
vote
3answers
108 views

What technology to use for home network

I live in panel-house (cube with concrete walls, reinforced with steel) which is part of bigger block. Recently I have successfully setup wifi network through the flat, but at the recieving end I have ...
0
votes
1answer
306 views

Several WiFi Access points, connected with wires, in the same network

I'm about to move my place of living and my company HQ at the same time to a new location. It's a 2-story building with rather thick concrete walls, and when I tried to put my wifi router/access point ...
0
votes
3answers
339 views

How to open a port such that a torrent client can both be used on Ethernet and Wi-FI connection?

From previous questions/answers I understand that forwarding one certain port to two different IP addresses is not possible. I have a laptop that connects through the router to the internet. When ...
0
votes
1answer
77 views

Capturing more WLAN frames than sending/receiving Ethernet frames

I'm trying to determine whether a computer capturing WLAN frames on an 802.11n network does this correctly. I do this by letting one computer (1) generate traffic by downloading some files, and ...