Tag Info

Hot answers tagged

2

Install libglib2.0-dev. You'll also need zlib1g-dev: apt-get install libglib2.0-dev zlib1g-dev .configure should run successfully with these two and the ones you've already installed.


2

Please check How can I avoid the prompts when installing a FreeBSD port? It's still pretty much the same, although I'd recommend setting BATCH in /etc/make.conf rather than your shell profile.


1

The configuration of the spans on your card depends primarily on what sort of lines your provider has given you so it is very hard for anyone to look at this configuration and know whether or not it is correct in your situation. However, generally, the alarm state of the span (GREEN, RED, UNCONFIGURED, YELLOW) depends solely on the configuration in ...


1

Sure this described everywhere. If you not want read, try this: yum update -y yum install kernel-devel -y reboot


1

I don't believe its possible with Microsoft DNS. An alternaitive might be to port forward the desired port to 53. Something like netsh interface portproxy add v4tov4 listenport=#### listenaddress=1.2.3.4 connectport=53 connectaddress=1.2.3.4 would work if DNS was using TCP, but is usually uses UDP so you'd have to find something that works with UDP too. ...



Only top voted, non community-wiki answers of a minimum length are eligible