23

One or many of the memory cards out of total 4GB (4x1GB) are failing. The following is memtest progress screenshot. It is always pointing to memory at 19xx MB and 50xx MB. Error bits are always 04000000. How can I determine which of those 4 cards are failing? The strange thing is that if I test them individually they are not failing. I've change Motherboard.

memtest memtest

Thanks

9
  • Maybe the modules are mis matched? Post your Motherboard model and revision.
    – Moab
    Mar 6, 2011 at 15:14
  • If the modules do not fail individually, then that is not your problem. I had this problem before, where I would get errors but they would be fine individually... Turns out it was the motherboard. It is possible that you have tested the memory in two damaged motherboards. Try bringing the RAM to a friend and testing it again. (Oh, and BTW, +1 for posting pictures, much appreciated) Mar 6, 2011 at 15:24
  • Also, I've noticed that the error bit is the same for each count. Was this the case with both motherboards you tested? Mar 6, 2011 at 15:26
  • @Moab: They were working for a long time and identical. MSI P45 Diamond.
    – Pablo
    Mar 6, 2011 at 15:26
  • @Breakthrough: Like I mentioned I've exchanged mobo once and now I have exactly same issue, same error bitmask. None of friends have DDR3 compatible mobos, unfortunately.
    – Pablo
    Mar 6, 2011 at 15:27

2 Answers 2

20

Use the process of elimination -- remove half of the modules and run the test again...

If there are no failures, then you know that these two modules are good, so put them aside and test again.

If there are failures, then cut down to half again (down to one of four memory modules now) then test again.

But, just because one failed a test, don't assume that the other doesn't fail (you could have two failing memory modules) -- where you've detected a failure with two memory modules, test each of those two separately afterwards.

Important note: With features like memory interleaving, and poor memory module socket numbering schemes by some motherboard vendors, it can be difficult to know which module is represented by a given address.

4
  • testing them individually does not show failure. I've tested like couple hours each.
    – Pablo
    Mar 6, 2011 at 17:57
  • +1. Try testing the modules in pairs, and if you're absolutely sure it's not the motherboard, use process of elimination to find the bad one. Mar 6, 2011 at 19:35
  • anyway... located a pair of modules which is failing. However, individually each module is not failing, only with pair and rarely. they are identical and not overclocked.
    – Pablo
    Mar 8, 2011 at 16:30
  • Are those memory modules hot to the touch after failing a test? If so, then it could be an overheating problem (and the modules may be fine in a system that doesn't cause them to run hot). Mar 8, 2011 at 16:32
2

I know it's an old post but maybe someone will have the same problem. It could be that the problem appears when the mainboard is entering in dual channel configuration, so the problem could be from the processor, especially some of the the pins from underneath it could be bended.

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .