9

I recently discovered that you can put a PCIe x4 card in a x8 or x16 slot.

With that said, what would happen if you took multiple PCIe SSDs and shoved them all into a 16x PCIe slot?

8
  • 25
    PCIe slots are keyed in a way that would prevent that. If you forced it, it would result in mechanical damage to the motherboard and device and almost certainly electrical damage to both as well.
    – Argonauts
    Aug 22, 2016 at 22:53
  • 4
    How exactly would you do that?
    – user253751
    Aug 22, 2016 at 23:15
  • 5
    @FatalSleep Your question presupposes you could.
    – user253751
    Aug 22, 2016 at 23:24
  • 2
    You can plug an x16 card into an x1 slot with some modification. Not sure how negotiation works with PCIe, but I think it's consecutive across the lanes. Lanes can't be freely reassigned though
    – Nick T
    Aug 22, 2016 at 23:43
  • 2
    @FatalSleep I was wondering what situation you were thinking of. Since you asked, you must have been imagining a way to do it.
    – user253751
    Aug 23, 2016 at 0:11

2 Answers 2

20

Nothing... The PCIE key slot would prevent a card being inserted anywhere except the front of the bus. Therefore, only one card can be entered in a slot at a time. If you were to remove the key, you may end up damaging your cards and/or your board.

The PCIE key is the first few pins, followed by a gap, and then the rest of the pins.

enter image description here

4
21

The computer would most likely not boot. It might short out.

See, a PCI x4 slot is not four as large as an x1 slot.

All PCI-e connectors have a shared layout: The first 18 pairs of connectors are for power supply, SMbus and JTAG communications, clock sync etc. Only then come the data pairs. This means there is only one way to correctly connect them.

Any second card in the same slot would at best connect (and not be able to use) the remaining data pairs. That is at best. At worst you'll connect its pins in an unexpected way, e.g. connecting the possible joined +12 power lines to differential signal paths. That will cause a short.

For more details on its pinout, please see Wikipedia: PCI Express.

Note that PCI-e bridges exist. You could put an x8 bridge card in an x8 (or bigger) slot and (via active hardware on that card) present two x4 slots, each with its own connector.

1
  • 2
    I assume that you meant JTAG not TJAG?
    – user
    Aug 23, 2016 at 7:48

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .