0 
  snmpwalk -v1 -c public $ip enterprises.10642.20.10.10.5.11.3.0;

  snmpget -v1 -c public $ip enterprises.10642.20.10.10.5.11.4.0;

  snmpset -v1 -c public $ip enterprises.10642.20.10.10.5.11.4.0 s 1664 ;

the snmpset was working with me fine before changed the community name from "public" to "loreal" after the change the snmpget is respond but the snmpset not respond >>>

C:\>snmpGet -v1 -c loreal $ip 1.3.6.1.4.1.10642.20.10.10.5.11.4.0
SNMPv2-SMI::enterprises.10642.20.10.10.5.11.4.0 = STRING: "********"

C:\>snmpSet -v1 -c loreal $ip 1.3.6.1.4.1.10642.20.10.10.5.11.4.0 s 1664
Timeout: No Response from 10.84.10.85

SO anybody have an idea!!

Improve this question
4
  • Obvious question: Did you actually change the community string on the target device?
    – Darren
    Sep 7, 2017 at 14:19
  • YES OF COURSE I changed with zpl command , this command line special for zebra printer
    – yazan
    Sep 7, 2017 at 14:35
  • The read community string is working, which suggests there is a separate one for write. Have you tried the snmpset with the old string?
    – Paul
    Sep 10, 2017 at 22:05
  • @Paul YOU have right the problem was in the ZPL command , I edited the command line and it's work now. thanks :)
    – yazan
    Sep 11, 2017 at 8:36

1 Answer 1

Reset to default
0

You can change CommunityName in ZEPRA printer by sending the commands ZPLII.

for more information: ZPL II Programming Guide

Description ^NN command: Use this command to set the Simple Network Management Protocol (SNMP) parameters. Format ^NNa,b,c,d,e,f

EX: 

 ^XA

 ^NN,,,test,test,test

 ^XZ

We can change it with SGD commands 

! U1 setvar "ip.snmp.get_community_name" "TEST"

! U1 setvar "ip.snmp.set_community_name" "TEST"
Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.