0

I wanted to use the ZTE MF60 router I own as an access point to extend my current 4G router. According to this, the device should be able to do so. However I haven't managed to enable the AP mode or configure the router using the my current firmware. How do I go about, any suggestions?

The following is the configuration I have for my device Network Security LAN

I used the same SSID and password on both routers, however changed the channel frequency on my 4G router to 1.

0

1 Answer 1

0

If you want to extend your 4G router with this one, it would need to support repeater mode which is told on your page that is not supported.

In mobile hotspots, Access Point is referred as a APN (Access Point Name) of your cell carrier so the connection comes from the cell network rather than a router.

The manual doesn't mention any repeater mode nor a way to extend a existing network.

2
  • bc.whirlpool.net.au/bc/hardware/… This had me confused, in that the wifi section says its supports AP mode but not repeater
    – NSCoder
    Oct 28, 2019 at 15:47
  • @NSCoder it's a access point from a GPRS/UTMS connection.
    – CaldeiraG
    Oct 28, 2019 at 15:50

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .