I removed the motor of my hard disk and this is the connector behind it... I just want to ask what is the purpose of each connector... among that 4 shown below, there could be pair for negative and positive for power... : ) but I dont know where it could be... also, what is the maximum voltage for the motor to function...

enter image description here

  • There is no way to answer that question... it will vary depending on the manufacturer and model of your hard drive. – Flimzy Jun 18 '11 at 4:15
  • Probably at least one pin is used for a wiegand sensor or something of the sort that is used to detect the rotational speed of the drive. – jcrawfordor Jun 18 '11 at 4:17
  • also, as far as voltage, probably 5v. start at 3.3 to be safe. – jcrawfordor Jun 18 '11 at 4:17

I don't know about the wires, but since you don't say what size drive it is:

  1. For a 3.5" hard drive, it requires +12V DC to run the motor, AND +5V DC to run the circuit boards. With SATA a third +3.3V DC is also used in addition to the other two.
  2. For a typical 2.5" hard drive, it requires +5V DC (often converted to +3.3V DC by an on-board voltage regulator).



I believe this varies from drive to drive. I would research your exact drive and get some specifics. Then if you can get your hands on a technical manual your life will be much easier.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.