3

i'm using an hp pavilion dv2000

i turned the wifi switch off by mistake, the LED turned orange and the wifi got disconnected.

and now when i turn the switch on, it remains orange and the wifi still isn't functional.

this happened before; i found a fix that worked searching google. it was done via terminal commands and i didn't have to download anything but i can't find the solution anymore!

wlan0 shows up when i use:

:~$iwconfig
#BLA BLA BLA
#...
wlan0     IEEE 802.11abg  ESSID:off/any
          Mode:Managed  Access Point: Not-Associated  Tx-Power=off
          Retry  long limit:7  RTS thr:off  Fragment thr:off
          Power Management:off

more results:

:~$ sudo ifconfig wlan0 up
SIOCSIFFLAGS: Operation not possible due to RF-kill

:~$ rfkill list all
1: phy0: WirelessLAN
        Soft blocked: yes
        Hard blocked: yes

:~$ sudo rfkill unblock all

:~$ rfkill list all
1: phy0: WirelessLAN
        Soft blocked: no
        Hard blocked: yes

:~$ sudo ifconfig wlan0 up
SIOCSIFFLAGS: Operation not possible due to RF-kill

it's still hard blocked! even though the switch is turned on; gives the same result eitherways

a direction to a page with a working solution is a much appreciated answer!

1
  • o snap! pro programmers r usually good with terminal commands so i hope someone might have gone through a similar problem
    – ZiGi
    Jun 24 '11 at 11:40
1

I had a similar problem on my HP ProBook 6450b after I upgraded from 10.10 to 11.04. I fixed the problem on my machine by disabling the "WiFi state switch" in the laptop's BIOS. (I wouldn't guarantee that this'll work for you though but it's worth a shot. It will mean that your switch will no longer do anything.)

If that doesn't work on its own then try also re-installing your WiFi drivers. Assuming your HP uses the Broadcom BCM43xx series of WiFi chipsets like mine, you can find how to reinstall your WiFi drivers here: https://help.ubuntu.com/community/WifiDocs/Driver/bcm43xx

My laptop uses the Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller so I re-installed the bcmwl-kernel-source package but you may need a different package.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.