My PSU started making some noises even when the fans were stopped. I also had USB problems (two USB devices burned) so I checked the PSU voltages with a multimeter.

I removed the PSU and connected it to a fan to see if it was on. I connected the green wire to a black wire and tested the voltages of the color cables on my 20 rails cable.

I noticed that my yellow (12V) rail was only showing 11.07V. Testing on the other yellow cables had the same result.

As this is bigger than the 5% margin of error I thought that I had a faulty PSU.

However after connecting the PSU to the motherboard, the values went up and my 12V rail went to 11.95.

Am I doing something wrong? Should I always test the PSU when it is connected to the PC?

1 Answer 1


Working properly without load is something not every ATX PSU does. To enhance the efficiency on real loads (or in case of bad PSU, on max load...) manufacturers do compromises, and unless you get really highy quality (and expensive) PSU, these compromises might mean the PSU does not work very well under 15% of max load.

On the other hand, the main problem with testing with motherboard is that load issued by the motherboard is very far from constant or controllable; thus your best bet is to add some 20-30W worth predictable +12V load when testing the PSU without motherboard.

And yes, I understand this can be hard to accomplish. In general, swapping in known-to-work PSU from other machine and seeing if that fixes the problem is the easiest solution, and the one I personally use. I even have a spare quality PSU just for this purpose..

Also, multimeter approach has the problem of missing small sags in power. For example, when CPU goes from zero load to full load, which happens quite a lot, the power draw from PSU to motherboard power circuitry can triple in milliseconds. With bad PSU voltages can drop here way below the nominal for few milliseconds, with is impossible to notice with multimeter but can still make the machine reboot or behave abnormally.

Oscilloscope would notice that, but they tend to cost real money.

  • Thanks for the detailed answer! Didn't know about that minimum load. Do you think it's safe to say that PSU is highly probable to be good if I test it while under load and don't notice any voltage variations? Aug 13, 2011 at 17:17
  • Unfortunately not.. most problems with PSUs are harder to spot, ie. they manifest in certain pattern of loads, ie. voltages going out of spec for only brief periods.
    – Zds
    Aug 13, 2011 at 17:21
  • I see, basically I can test if something is wrong (if under some load) but not if it's OK. And has a nice power supply is cheaper than an oscilloscope it seems that it's better to have a good one at hand. Thank you for the help Zds! Really appreciate it. Aug 13, 2011 at 17:28
  • If you end up buying a new one, I recommend getting some high quality one; you don't usually need high maximum wattage, but you need overall good quality power under various load conditions. The problem with PSUs is that problems from them are very hard to track down apart from swapping in another one and testing it. Meaning paying some extra for good power quality saves your nerves in the longer run.
    – Zds
    Aug 13, 2011 at 20:32
  • Yeah, I'm going for a corsair AX 750. Good efficiency, quiet and modular cables. Even so it's cheaper than the oscilloscope :) Aug 13, 2011 at 21:14

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .