I have the unfortunate task of writing a technical document, and I know the government is a stickler for unnecessary detail. Is there standard name for the standard computer screw? Also, what is the name of the standard disk drive screw?


Most screws in a computer are UTS 6-32 screws. 6-32 screws are used for your power supply, 3.5" hard drives, securing expansion cards, and the case panels.

The other common screw type is the metric M3-0.50 screw, which are used for mounting optical drives, floppy drives, and the motherboard.

To make it harder, there are also computer cases that ship with motherboard standoffs that accept imperial screws, not M3.

It's amusing that both imperial and metric screws are used in each computer, and rather annoying that these screws are fairly similar in size (although not in threading). This means that an M3 screw will fit in a 6-32 hole, and will even seem to screw in, but it won't stay in place well. A 6-32 screw will go in an M3 hole if you try hard enough, which results in stripping.

Note that the self-tapping plastic screws used exclusively for fans and some lighting are also standardized, although they're just standardized within industry as "self-tapping plastic screws" rather than being a standard mechanical screw size.

enter image description here

  • 4
    Great answer but I disagree about case fan screws being standardized. I have four or five different kinds in my build box. They vary in thread pitch, shaft size, head size, some have a self-tapping gouge taken out of the tip. Woe betide anyone who tries to put one of the thicker ones into a fan with smaller-than-average holes. Because of this I prefer to use the black two-part plastic expanding rivets where possible. – Adam Eberbach Aug 22 '11 at 7:18
  • 17
    Oh wow, there's an entire WikiPedia article on computer screws... – BloodPhilia Aug 22 '11 at 11:17
  • 2
    @Matias Nino: there are the laptop HDD screws which are tiny and have flat heads. – Dani Aug 22 '11 at 14:17
  • 3
    3.5" HDDs use 6-32, but 2.5" SSDs use M3. – Brian Minton May 2 '16 at 16:46
  • 1
    Hex-head screws in your PC will be #6-32 99% of the time (obvious exception is right there in the picture in this answer), but frustratingly round/pan-head screws in your PC will be 3mm perhaps only 60% of the time. (Regarding that picture: I can't find M3 machine screws with a dual socket/phillips drive anywhere online, I'm not sure where they sourced that one from!) – Mahmoud Al-Qudsi Oct 25 '17 at 23:23

6-32, and M3.

"Computer case screws"

  • 6
    I thought they were all M3s.. which would explain some issue i've had in the past... +1 for enlightenment! – Journeyman Geek Aug 22 '11 at 3:56

protected by Keltari Dec 8 '18 at 6:19

Thank you for your interest in this question. Because it has attracted low-quality or spam answers that had to be removed, posting an answer now requires 10 reputation on this site (the association bonus does not count).

Would you like to answer one of these unanswered questions instead?

Not the answer you're looking for? Browse other questions tagged or ask your own question.