0

I have the following set-up:

  • Linksys WAG320N modem-router connected to the internet via RJ11
  • Gateway IP for WAG320N is 10.0.1.1, subnet mask is 255.255.255.0
  • Static IPv4 address for my EA6500 router is 10.0.1.100

This modem is connected to my EA6500 router:

  • Linksys EA6500 connected to WAG320N on port 1
  • Gateway IP for EA6500 is 10.0.2.1, subnet mask is 255.255.255.0
  • EA6500 is set to auto-config DHCP mode under internet settings

I can connect to all my devices when I am connected to the EA6500, including the ones connected to the modem (WAG320N). But I cannot connect to EA6500's GUI or any devices connected to it when I try accessing them via the WAG320N.

What am I doing wrong?

  • This is by design you are trying to access an entirely different network that WAG320N isn't aware of. – Ramhound Apr 4 '13 at 15:57
  • Is there a way to make it work? Would a Bridged Mode on my EA6500 help? – Afzal Apr 26 '13 at 11:16
  • I managed to get full LAN access both ways, after reading and following this: ezlan.net/router_AP.html . But I cannot connect to the internet afterwards. Any alternatives? – Afzal Apr 26 '13 at 16:29

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.