I'm trying to assign a single key (F2) to the "find" command, but I cannot find it in the list of commands.

As you can see here, I can see the "find" command when it comes to add it to the Quick Access Toolbar:

enter image description here

But when it comes to assigning keyboard shortcuts, the "find" command is nowhere to be found:

enter image description here

I'm assuming that the reason it is not displaying it is because it has a built-in CTRL+F shortcut, but I want to change that.

In short: how can I assign F2 to the "find" command?

  • 1
    Office 2003 shows it as EditFind, so it's probably listed in 2007 as HomeFind. (I don't have a copy of 2007, so I'm not 100% sure about that.) – Davidw May 2 '13 at 1:37
  • @Davidw - Thanks. That was it. It's listed as editFind. Go figure. If you post this as an answer, I'll accept it. – MegaHit May 2 '13 at 1:40
  • Also see last bit of my answer here. – Karan May 3 '13 at 13:59

It's listed by the section that it is part of in the ribbon, so it would be EditFind.

enter image description here

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.