What I want to do is connecting several IP cameras to my LAN with wireless router/AP.

I have a main USRobotics modem/router/AP ( and all my computers are connected to that one using 192.168.1.* subnet and DHCP (with pool from to

I would like to connect 3 IP cameras (with static IPs,101,102) to a switch (cheap, simple 8 port switch) and the switch to TPLink MR3020 nano router ( with cable. And at the end I want MR3020 to connect my main USRobotics with wireless.

And I would like to access IP cameras from the computers? How can I do that?

MR3020 only have one ethernet port and wireless interface. I have stock firmware on MR3020 but if it's not enough, I can setup OpenWRT or DD-WRT on it.

Below you can see the sample diagram. Connect diagram
Click for full size

  • In my experience the best solution would be to have the camerasconnct to a dvr that would record the video and manage the cameras then you would only have to worry about 1 ip to manage. And if you wanted access off-site you could open the port for the dvr
    – TheXed
    Commented Jan 25, 2015 at 3:16

1 Answer 1


You did not specify how you configured MR3020 router, but it seems like the WAN interface will connect to your USR router wirelessly.

In this case, you have to put your MR3020 router and IP cameras to a different subnet (i.e. 192.168.2.*). Then you can setup port forwarding on your MR3020 to forward specific ports to each camera individually. The WAN port of MR3020 must be assigned to a static IP (i.e. This way you can access each camera by accessing your MR3020 WAN IP and ports you specified.

Example (I'll use port 80 on your cameras as an example) of MR3020 port forwarding list:

   1080 ->
   1081 ->
   1082 ->

This way you can access camera 100 using, camera 101 using, and camera 102 using

If you do MR3020 as a bridge, then you can keep your cameras in the same subnet 192.168.1.* and access them directly from your PCs.

  • Thank you very much. I've done it using different subnet and port forwarding but I would like to access them directly, unfortunately I couldn't make it work with bridge mode, it seems bridge mode doesn't recognize switch connected to ethernet interface or I am doing something else wrong. Commented Jan 25, 2015 at 2:09
  • When you do routing, it uses NAT (Network Address Translation) which does not allow you to access anything directly because it's "behind the NAT". You may try to get an alternative firmware for your nano router (OpenWRT, etc) which can create bridge mode for you.
    – nochkin
    Commented Jan 25, 2015 at 2:13

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .