5

I'm writing a really long page to document a compiler and I was thinking that it would be nice if the doxygen highlighting would stick around. Only if I do a search to further down the file, it loses track since the number of line in that one comment is really large (1066 right now).

I have found that you could tell the system to synchronize from the start of the file using:

:syntax sync fromstart

Which works great. Now I was wondering whether I could have that (or maybe define the number of lines?) in the modeline info so that way it works as is each time I open the file.

I also noticed the minlines, but that's also something specific to the syntax and it does not look like I can just write:

vim: minlines=10000

This is viewed as an error.

  • You can only have set commands in a modeline. – romainl Jul 1 '15 at 5:09
  • Yeah... and I was thinking that the minlines and fromstart were no set commands... too bad. – Alexis Wilke Jul 1 '15 at 6:58
2

I believe what you're looking for is what's known in Vimscript as an autocmd on a BufEnter event. Adding the following line to your .vimrc will execute the desired command for each file you open:

autocmd BufEnter * :syntax sync fromstart

If you only want to open on certain file extensions, just replace the * above with a more specific pattern for the file name, like *.at or somesuch. If you're still losing your highlighting, you could also trigger the autocommand on some other event like entering Insert mode.

There's a lot you can do with these autocommand-event pairs. If you're interested in learning a bit more about them, I would also recommend reading over a few paragraphs of this online guide. For the sake of clarity, or for those that come after you, here's a great visual shorthand from this guide:

:autocmd BufNewFile * :write
         ^          ^ ^
         |          | |
         |          | The command to run.
         |          |
         |          A "pattern" to filter the event.
         |
         The "event" to watch for.

The above is an example of an autocommand that would automatically save a file whenever you enter a command like vim newfile from the command line.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.